Hi karljchan,
Welcome to the 10forums.
Please fill in your system specsPlease go to
this site and download the tool. The tool will give you detailed information about your system specs, please fill in your system specs more completely.
How to fill in your system specs:
Diagnostic Test
DRIVER VERIFIER
Warning
Please make a backup of your important files and get your rescue media or
create one.
Please create a restore point.
Please read and run driver verifier.
A windows driver is blamed in the crash, but that usually means that a 3rd party driver is actually the cause.
Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.
Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.
If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.
Note
Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.
Code:
IRQL_NOT_LESS_OR_EQUAL (a)An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high. This is usually
caused by drivers using improper addresses.
If a kernel debugger is available get the stack backtrace.
Arguments:
Arg1: 0000000000000008, memory referenced
Arg2: 0000000000000002, IRQL
Arg3: 0000000000000000, bitfield :
bit 0 : value 0 = read operation, 1 = write operation
bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
Arg4: fffff801b50bdba1, address which referenced memory
Please Run Memtest86+
Information
Please download from this site only
http://www.memtest.org/ in the middle of the page are the Download links, you can download the ISO.zip or the Auto USB Flash Drive installer.zip
Extract the Zip file. If you chose the ISO image, burn it to a CD using Windows Disk Image Burner or any Image burner you may have. If you downloaded the Auto USB installer, extract it, insert your USB 2.0 Flash Drive and take note of the drive letter. Run the installer, select the Flash Drive Letter, check the format box and press next. It will install memtest86+ to a flash drive. You can use either V4.20 or V5.01. Boot from your selected media. If you use V5.01 it will tell you to press certain buttons at the start, please press no buttons. The test will begin on it's own and continue to run until you stop it. It needs to run for 8 complete passes or until you receive an error. If you receive an error, stop the test. Even 1 error is a fail. Each pass tests a different part of the ram and each of the 10 tests in each pass tests something different. It takes a minimum of 8 passes in the same session to completely test the ram, more passes are better. It is quite a long test and will take several hours depending on how much ram you have. Due to the time length it is best to run overnight. If you have any questions, please do not hesitate to ask.