New
#661
On the new Iso, Macruim Free eventually loads after 2-3 mins? , with what looks like, it trying to install/load a generic USB3 (hub?) driver , (Snipping Tool not on ISO ( or I missed it) or I would of got image for you)
Minitool Partition Pro is loading fine too now for me , tried it after Macrium Free.
Last edited by Kbird; 07 Jul 2016 at 18:32.
FSCapture - replaced snipping tool
You may also want to try and pre-load your raid driver into pese image
OK - so have one program request = add back snipping tool...
OK - so have second program request = add back MR Home...
YES, I'm taking requests and suggestions...
For Next release...
Thanks again.... it does sound like I need to do a MRF iso and intergrate it instead.
I guess MR Home is a Trail version ? you don't need a Key / license to run it do you ? I was wondering if that is why it wont load on .125 as MRF runs on .707
I was not aware of FS Capture actually......
Always advisable to format wih FAT32 so that it will be compatible with earlier version of EFI firmware.@Kbird
Should the USB Drive be Fat32 or NTFS Formatted? does it matter?
My first post on Forum, will try to endovour to do my best within guidelines. I am working on a Win10 installation for my neighbour on ASUS TP200SA. The job has just about gone over my head. Main problem I have had, system would not upgrade to the November ISO, to me it looked like it did.
I am however not very familiar with Win10, though I believe I am past this stage and now trying to use MacriumReflect Free to work out a simple recovery system for the owner when I discovered that Macrium Reflect Repair stick lost the keyboard and touchpad.
Searching for some help, I stumbled on this thread. The WinPE boot system seems perfect to experiment with Macrium and see how keyboard/touchpad perform. If need be export drivers from host system if I understand correctly.
During the download of WinPESE-64 around 70% we had a power blackout for an hour, unfortunately Firefox was unable to resume, using the trick to remove the *iso.part to another directory then restart download. As I have blown my download quota I will have to wait another 24 hours before starting over again.
My question the download link in post #1 is that "resumable" or is it Firefox that fails the operation. Firefox is very basic, I have not customised it in any way yet.
My post above is now of less interest as I have downloaded a new copy, WinPESE-64 and made a boot stick. Seems I have been caught out as the ASUS TP200SA running Win10, response is "Not enough memory to make a RAM disk" ooops this pc has only 2 GB or RAM.
When reading the whole thread I must have missed the specs needed to run the WinPE.
Question: How much RAM is needed to run the WinPESE-64?