New
#1
Clean install of W10 - Unable to boot from USB drive?
Hi all, first post, so hoping I'm in the right place :/ ...
I'm literally pulling what hair I have left out with this, normally this is a routine task for me, but I'm well and truly stumped, so thought I'd ask a Windows 10 community ...
I have Windows 10 Education x64, I have had it for over 6 months now, and I've had no real problems. I solely use my C drive for the OS, and once in a while I like to format it and re-install Windows to keep things smooth. Given that the C drive only contains the OS, this is normally a pain and hassle free routine that doesn't take long at all ...
This time though, for whatever reason the PC locked up during the installation, it was stuck on 20% for over 6 hours, so with no option I had to shut the PC down and hope it would resume or start again .. which it didn't, and I now had a PC that wouldn't boot up, and given the ISO for my W10 was on another HDD I couldn't really do much ...
I grabbed my USB pen and using the MS Media Creation Tool on another PC, I was able to create a bootable USB pen with a W10 image. Back at my PC, I did the usual changing of the boot order, shoved the pen in and was able to successfully install W10 again ... but given that I didn't un-check a tick box on the Media Creation Tool, I now had installed the 32bit version of W10 and not the 64bit one that I wanted ...
Ok, no problem, so I'll just repeat what I've done again, but this time with a 64bit ISO, even better because now my PC boots up, I can just use the ISO that came when I purchased it ...
And that's where the problems begun ...
I formatted the USB pen and used Rufus to burn the ISO to it, which it successfully did, I changed the boot order again, but it didn't try to boot from the pen like before, it booted Windows from the C drive. After messing about in BIOS and giving it no option but to only boot from the USB pen or nothing at all, it chose the latter, giving me the "DISK BOOT FAILURE" message. I rebooted again and used the pressing ESC option to select the booting device, I chose 'Removable', but I was informed that there was "No bootable media present" ...
Since then I've tried 3 different ISO to USB programs including one by MS, I've tried a different USB pen and I've tried a couple of different ISOs that I've either downloaded from MS or got by using the Media Creation Tool. On each occasion that I've burned the ISO, when you reset the PC, the LED on the pen flashes, so the computer recognises it and is at least 'trying' to boot from it. Also to note, after burning the ISOs, both pens show all the files needed including the 'autorun' file on them ...
I've trawled the net but am unable to find any answers, so could anyone be kind enough to shed some light on this as I'm literally all out of answers and options as what to do next, other than stick with the 32bit version, which I don't want to do
Knowing me, it's probably something stupid and easy that I've missed ...
Regards
Stef