Windows 10: Adaptec AHA-2940 SCSI card and Windows 10

  1.    20 Jan 2017 #1

    Adaptec AHA-2940 SCSI card and Windows 10

    I have a Windows 7 system and a scanner connected to an ADAPTEC AHA-2940 SCSI card. This scanner is a pre-press professional scanner and there are no other scanners available of the same quality.I would like to update to Windows 10 but I am not sure if Win 10 is compatible with this SCSI card.So my question is
    Has anyone managed to get this card working under a Win 10 environment?Your help is much appreciated.
      My ComputerSystem Spec

  2. Posts : 1,855
    Win 10 X64 Pro 1803 17751.1
       20 Jan 2017 #2

    I have no personal experience with the card.

    I see that the latest drivers for it are for Windows 7.

    A quick check doesn't show any current cards with 50 pin outputs like the AHA-2940. However, there are 68 pin ones, and there are 68 to 50 pin adapters.

    The most obvious choice*is to stay with Win 7. MS will support it into 2020.
      My ComputersSystem Spec


Related Threads
The FAT 16 File system is externally interacting (Connected over USB in the form of Mass storage device)with Windows 10 (Anniversary update Updated PC.) The Communication between Host and client is very slow ,it is not able to transfer adequate...
Everytime my Seagate Expansion Portable Drive is plugged into my PC (Windows 10 64bit), Window's Event Viewer repeatedly reports warning messages: Event 129, UASPStor Reset to device,\Device\Raidport1, was issued
Is anyone using a UAS device successfully on 9926? I have a Iomega eGo USB 3 1TB drive which connects through USB Attached SCSI when running 9926 on 2012 Macbook Pro hardware. The drive is fine (works through USB2 on Thinkpad) and the Macbook is...
Adaptec 39320A SCSI drivers in Drivers and Hardware
You can download and use the Windows 7 drivers from the Adaptec support site, these seem to work fine (at least on x64). Other Adaptec cards may also work using the Windows 7 drivers. HtH Dave
A few minutes ago, a message balloon popped-up in the notification area formerly known as the system tray that said "msft virtual scsi mounted to F:", as near as I can remember. It went away after a few seconds, and did not leave a message in the...
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 19:55.
Find Us