Confussion with BSOD


  1. Posts : 9
    Windows 10
       #1

    Confussion with BSOD


    Hey guys!

    I have some confusion over my BSOD issue and hardware fault I have recently had.

    Starts with my external Hard Drives, although this has often happened occasionally before, but this time, it really caused issues this time. Randomly for no reason, my external Hard Drives will disconnect then randomly reconnect again without out it being touched.

    But this time one disconnected but didn't reconnect, so I unplugged, then a BSOD came up. The system restarted, before Windows booted up, I replugged the Hard Drive, but found it wasn't found by Windows, I unplugged, then plugged in again, then BSOD came up.

    Now when powering up again, the computer had some power issue, it would power for about 2 seconds then cut off, few seconds later, it would do the same over & over & over, until I pulled the plug. THis would always happen.

    I was was recommended to take all my RAM sticks out then put back in again. Amazingly this worked wonderfully, not had any issues as yet. But any reason why & what caused this? To prevent such an event again.

    Thanks, Ryan

    Error reports:

    Crash dump directory: C:\Windows\Minidump

    Crash dumps are enabled on your computer.

    On Fri 07/08/2015 23:09:07 GMT your computer crashed
    crash dump file: C:\Windows\Minidump\080815-33984-01.dmp
    This was probably caused by the following module: ntoskrnl.exe (nt+0x14D220)
    Bugcheck code: 0xA (0xFFFFFFFFFFFFFFF8, 0x2, 0x0, 0xFFFFF801D5846D79)
    Error: IRQL_NOT_LESS_OR_EQUAL
    file path: C:\Windows\system32\ntoskrnl.exe
    product: Microsoft® Windows® Operating System
    company: Microsoft Corporation
    description: NT Kernel & System
    Bug check description: This indicates that Microsoft Windows or a kernel-mode driver accessed paged memory at DISPATCH_LEVEL or above.
    This appears to be a typical software driver bug and is not likely to be caused by a hardware problem.
    The crash took place in the Windows kernel. Possibly this problem is caused by another driver that cannot be identified at this time.



    On Fri 07/08/2015 23:09:07 GMT your computer crashed
    crash dump file: C:\Windows\memory.dmp
    This was probably caused by the following module: ntkrnlmp.exe (nt!KeBugCheckEx+0x0)
    Bugcheck code: 0xA (0xFFFFFFFFFFFFFFF8, 0x2, 0x0, 0xFFFFF801D5846D79)
    Error: IRQL_NOT_LESS_OR_EQUAL
    Bug check description: This indicates that Microsoft Windows or a kernel-mode driver accessed paged memory at DISPATCH_LEVEL or above.
    This appears to be a typical software driver bug and is not likely to be caused by a hardware problem.
    The crash took place in the Windows kernel. Possibly this problem is caused by another driver that cannot be identified at this time.


      My Computer


  2. Posts : 14,903
    Windows 10 Pro
       #2

    Hi DeadSonRisingxD,

    I'm very sorry for the delay, there aren't many people in this section.
    Are you still requiring help?
    If so, please read BSOD Posting Instructions
      My Computers


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 15:05.
Find Us




Windows 10 Forums