New
#1
Loop: System Thread Exception Not Handled, Bad System Config Info
This Windows 10 (ver: 10.0.18362.592) cycles through these two messages. After Bad System Config Info, it goes through Preparing Automatic Repair but then gives the System Thread Exception message. No specific files are indicated.
I booted with a Windows 10 installation media dvd. The options with that dvd booted are:
Start Up Repair
Command Prompt
Uninstall Updates
System Restore
System Image Recovery
The Start Up Repair did not achieve anything. The problem may have occurred during this past week's update. I was not around then. I tried to use the Uninstall Updates but that failed.
From the Command Prompt I tried to get into Safe Boot.
I entered:
bcedit /set {default} safeboot network
and got:
The boot configuration data store could not be opened. The requested device could not be found.
I was able to put the extracted V2 log collector on a flash drive and find it on the desktop through the command line. However, I could not figure out how to run the .lnk file. Is there a way?
Not sure what to try next.
Thanks,
Jeff
- - - Updated - - -
Here's some more information:
Motherboard:Asus X99-DELUXE II LGA2011-v3/ Intel X99/ DDR4/
Quad CrossFireX & Quad SLI/ SATA3&USB3.1/
M.2&U.2&SATA Express/ WiFi/ A&2GbE/ ATX
Processor:Intel Boxed Core i7-6850K Processor (15M Cache, up to 3.80 GHz) 6 core, 12 thread. 140W TDP, 40 PCIe lanes
Graphics Card:PNY Quadro K1200 Graphic Card - 4 GB GDDR5 - PCI Express 2.0 x16
Boot Drive:Samsung 950 PRO Series 512 GB - PCIe NVMe - M.2 FF Internal SSD