New
#1
Windows 10 BSOD: alternating 0xc0000001 and Inaccessible boot device
Hello.
I have a problem starting my computer from yesterday. Attempting to boot the system leads back to the bios. I've tried various actions with bcdboot and bootrec and there are still problems
I run the installation of windows 1803 (with such a version of buildu I have a pendrive) I go to the console and I have these symptoms:
Bootrec / fixmbr - correct operation
Bootrec / fixboot - access denied
Bootrec / scanos - finds one installation of windows [D]
Bootrec / rebuildbcd - finds one installation of widnows and then no matter whether you choose [Y] or [N] or All I receive the message: The requested system device can not be found.
Disk configuration (behind diskpart)
list disk:
Disk 0 Online 1863GB 0
Disk 1 Online 476GB 0 GPT *
Disk 2 Online 14GB 0
Disk 3 No media
list part:
Disk 0
partition 1 - primary 1863GB
Disk 1
partition 1 - recovery 450GB
partition 2 - 100MB system
Partition 3 - Reserved 16MB
Partition 4 - primary 467GB
Just on partition 4, Windows 10 is installed - only that I can not run it
I made the commands found on one of the forums:
Automatic repair using the System Repair Tool during commissioning
MBR repair
Command 1: bootrec.exe / fixmbr
Command 2: bootsect.exe / nt60 all / mbr
boot sectora repair
Command 1: bootrec.exe / fixboot
Command 2: bootsect / nt60 C: (repair partition c :)
Command 3: bootsect / nt60 SYS (repairing the system partition)
Command 4: bootsect / nt60 ALL (repair of all partitions
reconstruction of the BCD warehouse
Command: bootrec.exe / rebuildbcd
Below I will show only those which have been wrong:
bootsect / nt60 all / mbr- for drive F: parameter is not valid - you can not open root directory
\ Device \ HarddiskVolume5 - the parameter is incorrect - you can not open root directory
\ ?? \ PhisycalDrive1
Bootcode is only updated on MBR. Different partitioning scheme is used on this disk
bootsect / nt60 SYS - target volumes will be updated with BOOTMGR compatible bootcode
The system partition not found - The specified system device can not be found
Bootsect / nt60 ALL
D: (\\ Volume {xxxxxxxxxxxxxxxxxx} Updated filesystem bootcode. The update may have been disabled during the update. Access denied.
F: (\\ Volume {xxxxxxxxxxxxxxxxxx} can not open root directory. Incorrect parameter
\ Device \ HarddiskVolume5 - the parameter is incorrect - you can not open root directory
After that I started the computer. It is unchanged. The system does not start, after about 10 seconds. opens the uefi bios.
One more symptom is that something is wrong there were blue screens with the information "Inaccessible boot device" and now it does not even have such a message, it immediately enters the bios
I am asking for further advice. I want to run windows from this disk. The new installation is not taken into account.
If I disable the UEFI mode in the BIOS bias then the system tries to load, but I get an error: "Inaccessible boot device"
When I turn on the UEFI again then for about 1/2 sec. my blue death screen will flash with error 0xc0000001.
I do not know what to do next?
I get alternately blue screens with errors:
-inaccessible boot device
- error 0xc0000001
I don't prefer make new install. Please help for repair my PC
Last edited by Jedrek; 10 Oct 2018 at 04:34.