Announcing Windows 10 Insider Preview Fast+Skip Build 17017 for PC Insider

I can privately share my 17017 ISO if any of you is tired of trying. :)

WEKJR said:

Installed 17017 last night and all seemed fine. Turned off my desk side system as usual and this morning I can no longer reboot. I have been dual booting Win 7 Ultra on one SSD and Win 10 64 Pro Insider on a second SSD. At boot I can choose either operating system. Today it spins the start up icon 1/2 rotation and says "Page Fault in non page area Volsnap.sys." It also tries to repair and fails.

Any idea for a fix?

WEK

Definitely just a case of drive errors. Common issue with dual booting machines.
I have that issue from time to time.
I just scan the drive for errors and repair it, Works most of the time.
Sometimes I just restore the system partitions (not the main OS partition) from Macrium image,
But if that still fails, I just restore everything from image.

WEKJR said:

I guess I'll have to reinstall 16299.15. Not what I wanted to do. Burning the DVD right now.

WEK

I restored an image from prior to problematic download from MS. Now I am downloading again to see if I can get a successful install. Good luck to you with your approach.

Set up a dual boot system and primary system failed so I restore from Macrium image to 16299.15. Download of 17017 started immediately with other downloads.

Malicious removal tool.

Defender

Update for x64 systems

magilla said:

I restored an image from prior to problematic download from MS. Now I am downloading again to see if I can get a successful install. Good luck to you with your approach.

Not successful -- still getting the same message with volsnap.sys being culprit causing pagefault in non-paged area
This is only on Skippy -- other computers updated without problem.

WEKJR said:

Installed 17017 last night and all seemed fine. Turned off my desk side system as usual and this morning I can no longer reboot. I have been dual booting Win 7 Ultra on one SSD and Win 10 64 Pro Insider on a second SSD. At boot I can choose either operating system. Today it spins the start up icon 1/2 rotation and says "Page Fault in non page area Volsnap.sys." It also tries to repair and fails.



Any idea for a fix?

WEK

I found that this occurred when I enabled system restore and then rebooted. Luckily, I created an image right before I did anything. With System Restore points disabled, it boots normally.