Search:

Type: Posts; User: alphanumeric

Page 1 of 10 1 2 3 4

Search: Search took 0.07 seconds.

  1. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    The Zero 2 W has a custom SOC, that needs custom...

    The Zero 2 W has a custom SOC, that needs custom firmware. It's new based on old, lol. The ram is beside the processor not on top like the Pi Zero POP layout. And all in the one package not two...
  2. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    7 Pi's and 1 PICO running and in use as I type...

    7 Pi's and 1 PICO running and in use as I type this post. :p
  3. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    You should get close to 3A+ performance or match...

    You should get close to 3A+ performance or match it if you can reach 1.4GHz. Your going to want to add a heatsink so it doesn't throttle the clock back on you.
    Pi 3A+
    Broadcom BCM2837B0,...
  4. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Somebody finally released a version of Motion Eye...

    Somebody finally released a version of Motion Eye OS that will run on a Pi Zero 2 W.
    Release 20211113 . jawsper/motioneyeos . GitHub
    Gave it a quick look see yesterday and it wasn't bad. The Zero 2...
  5. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Rewired my Snow Flakes blinky lights today....

    Rewired my Snow Flakes blinky lights today. Snowflake: a project by Lucky Resistor Pimoroni
    I had one that would not work when connected with the included ribbon cable. It would work with wires...
  6. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    No, non of my PC's meet the new hardware...

    No, non of my PC's meet the new hardware requirements. On the Pi side, its debatable if its legal to do it. And what's out there for a Pi is very buggy and missing some bits, its not really fully...
  7. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Round two of my IR LED array tests. They all lite...

    Round two of my IR LED array tests. They all lite up, and only get warm. My resistors are getting hot though. I may have too swap my single 10 ohms for two 20 ohm or three 30 ohm. I thought my...
  8. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Click on "Settings", top right next to My...

    Click on "Settings", top right next to My Profile.
    Then go to Miscellaneous > Attachments
    It looks like you can only delete recent ones. The check boxes stop part way down for me.
  9. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    I don't know? You can edit that post and remove...

    I don't know? You can edit that post and remove any uploaded images. I don't know if that also removes any stored copies on the server though?
  10. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    The junction voltage ( the voltage they actually...

    The junction voltage ( the voltage they actually turn on at ) varies by color, and also a little from LED to LED of the same color. If you buy them in packs of more than one, they are usually pretty...
  11. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Powered up my IR LED array. It worked, nice and...

    Powered up my IR LED array. It worked, nice and bright, maybe a bit too bright though? The LED's started getting hot so I shut it down. Just finished reworking it for trial no 2. I went with 2 in...
  12. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Getting ready just in case the power fails when...

    Getting ready just in case the power fails when this bad weather arrives. Got my laptop fully charged so I can play some games to kill time, lol. Also charged up my MP3 player. Dug out all my power...
  13. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Right now is when I wish I had it all setup and...

    Right now is when I wish I had it all setup and working. Missy is growling at something "she" sees out the living room window. My stock Pi Camera can't see it, its just too dark out. If that array of...
  14. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    I'm still researching it a bit before I actually...

    I'm still researching it a bit before I actually power it up. Normally you have a current limiting resistor in series with the LED.
    Mine is +5V--LED--LED--LED--Ground.
    LED Calculator

    If I do...
  15. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    It's 24 super-bright 5mm IR LED's. They have an...

    It's 24 super-bright 5mm IR LED's. They have an "approximate" 1.6v forward voltage. It varies a little bit diode to diode. I wired them up in groups of 3 in series. That's ~4.8 V which will be fine...
  16. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    It will be used with my NOIR camera, hint hint....

    It will be used with my NOIR camera, hint hint.
    This is one of my few exceptions to not getting single color LED's. They are 940nm.
  17. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Nope, not blue.

    Nope, not blue.
  18. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Changes night into day but you can't see it. ;) ...

    Changes night into day but you can't see it. ;)

    351682
  19. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    I'm not sure if there is room for an extension?...

    I'm not sure if there is room for an extension? It's not as big a deal as I may have made it out to be, just a bit of an inconvenience. It's usable as is, the extra speed bump, if it supports it...
  20. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    One of my Pi 4B's is running at 1.8. I have one...

    One of my Pi 4B's is running at 1.8. I have one in a heatsink case that was easy to setup. I just swapped it in place of my Pi 400 to do the setup on a fresh Bullseye image. My other one is in my...
  21. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    That is cool, like the colors. :thumbsup:

    That is cool, like the colors.
    :thumbsup:
  22. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Nope, wasn't me. I shy away from the single color...

    Nope, wasn't me. I shy away from the single color stuff, I'm an RGB kind of guy, lol.
  23. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    I like how Bullseye notifies you that there are...

    I like how Bullseye notifies you that there are updates, lets you see them (list them), and then install them, all with just a few mouse clicks.
    :thumbsup:
  24. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    A 4A is what I'd like to see.

    A 4A is what I'd like to see.
  25. Thread: The Raspberry Pi Thread [6] by alphanumeric
    Forum: Chillout Room
    Replies 579 Views 48,275

    Just booted mine up. It wouldn't fit correctly in...

    Just booted mine up. It wouldn't fit correctly in the official Pi Zero case. I got it in but no HDMI signal. There is a lip on the HDMI jack that keeps it from going in the cutout on the case. I was...
Results 1 to 25 of 250
Page 1 of 10 1 2 3 4
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 07:17.
Find Us




Windows 10 Forums