Alright thanks again

Yes thank you so much for your support and patience. I suppose I will be waiting for a fix from Windows. Is there any way in which I can let them know of this issue?

Well. Since there is an SSD running the OS it booted up fast from hibernate, but didn't get any errors when I woke it up. Now to just figure out how to put hibernate as an option from my start...

Here is the latest dump. I guess the issue is not the end of the world. Could be worse I suppose. So you are suggesting that hibernate might be a better solution that letting it sleep?

Hey sorry I had an early morning shift yesterday and was exhausted. The repair ran and stated that it completed successfully.

However after doing this I put the computer to sleep and it went to...

Unfortunately it crashed again. Looking with Blue Screen View showed it was caused by hal.dll and the ntoskrnl.

It states that "Windows Resource Protection did not find any integrity violations."

Yes I consistently have been able to recreate the stop message when I put the computer in sleep or it goes to sleep on its own and I try and wake it. At no other time have I had a stop message since...

They are showing up in the marvell ATA controller config and not the ATA port information page. The DVD drive is in port 3 now though.

Figured it out. It was plugged into the GSATA ports. It was...

Alright so I did some switching and now both hard drives are showing up on GSATA port 0 and 1 with the HDD on port 0 and the SSD on oort 1. But you were saying that having the ssd on the marvell...

I updated my answer on the ports in previous post. Don't know if you saw that or not. Searched again on Toshiba's website. There are no utilities or drivers available.

I went to the website and input my model number. It came back with no drivers. I will look again though.

On the marvell ATA controller configuration page it shows no ports connected.

Alright sorry just found the ATA port information.
ATA port 0 is empty
PORT 1 Has the 1 TB hard drive
Port 2 has...

Alright SATA controller (s) are enabled and set to AHCI

Marvell is in AHCI mode but it all ports it states Not Present. For both port 0 and port 1 and the same situation for GSATA. ACHI mode and...

With command prompt?

Hello and thanks for the welcome and reply. I updated my specs to the best of my abilities.

I guess since I'm not running a dual graphics card set up I'm not running Raid. This is a self...

So upgraded from 8.1 Pro. I never had any problems with 8.1 other than the occasional crash here and there, but nothing exceptional. Now every time that I try to wake the computer from sleep I get...