New
#1
Hibernate not working after memory upgrade
After adding more memory/ram hibernating the pc results in a 'boot failure detected' and the memory speed being changed down to 1331Mhz from 1866Mhz.
I had run memtest86+ after fitting another 2x4Gb memory chips. These being identical to the existing two chips. I have tried turning hibernate off and then on again. I have also tried 'powercfg /h /size 75%' and 100%.
powercfg /a
The following sleep states are available on this system:
Standby (S3)
Hibernate
Hybrid Sleep
Fast Startup
The following sleep states are not available on this system:
Standby (S1)
The system firmware does not support this standby state.
Standby (S2)
The system firmware does not support this standby state.
Standby (S0 Low Power Idle)
The system firmware does not support this standby state.
It is strange that when I do try to hibernate the pc it goes quite for a long time before rebooting with the bios error and the memory speed showing as 1331. I have Corsair CMZ8Gx3M2A1866C9R times four with the bios set to XMP.
There are no particular errors in the event log, as the pc is just rebooting and not returning from a hibernate state.
What else can I try?
Thanks
Rob.