New
#1
WerFault.exe - Application Error
Hello,
I just upgraded from Windows 7 to Windows 10 today, and since the update when I start my laptop I receive an error message that says the following:
WerFault.exe - Application Error
The instruction at 0x00007FF9614DBFB0 referenced memory at 0x00007FF9614DBFB0. The memory could not be written.
Click on OK to terminate the program
When I click OK, the same error pops up immediately four or five times until it finally closes. But it will pop up again in a few minutes, and the process will repeat.
Is there a way to fix this?
As a side-note: I can't seem to scroll my screen using two finger slide anymore. Any fixes for this as well?
Thank you very much!