Unigine Superposition

Paul for it to work you need to have fans set to auto, and you can still set curves for two too.
And disconnect the fan sync(?)

Cliff S said:

Paul for it to work you need to have fans set to auto, and you can still set curves for two too.
And disconnect the fan sync(?)

Interesting Cliff, so you are saying Afterburner can work with the FTW3 with all 3 fans? I will test it out tomorrow and let you know how it goes.

Yes with Firestorm you choose 1 to control the 2 main fans, and choose 2 to use the end fan.

I leave it on Auto when I`m not gaming, our house is so dusty, and the pets, ohhh the pets. It stays around 36c if I`m just browsing.

If I let them run all the time, my PC would be 1 big hair ball

I gotta find 8 black solid PCI slot covers, all these ones with the holes in them just pull more dust in.

Found some, and ordered 2 packs.

5pcs/lot Black Hard Steel PCI Slot Covers Bracket w/ Screws, Full Profile Expansion Dust Filter Blanking Plate for PCI - Newegg.com

paulpicks21 said:

The 3 fans don't work on the Zotac with Afterburner, same as the FTW3 mate. Wish they would address this in Afterburner as it's a great bit of software!

In the latest MSI AB release notes I'm quite certain Unwinder said he will never support the EVGA iCX fan system so I guess that's that.

paulpicks21 said:

Interesting Cliff, so you are saying Afterburner can work with the FTW3 with all 3 fans? I will test it out tomorrow and let you know how it goes.

No with Zotac

Kol12 said:

In the latest MSI AB release notes I'm quite certain Unwinder said he will never support the EVGA iCX fan system so I guess that's that.

Exactly the asynchro iCX fan control, but temperatur sensor support is there, so for benching it can still be used, but the fans on iCX cards will all run the same speed.

Anyway Unwinder explains thing here: RTSS 6.7.0 beta 1 | Page 98 | guru3D Forums

From Read Me:

Added asynchronous dual fan control support for reference design NVIDIA GeForce RTX 20x0 series graphics cards. Please take a
note that only 100% NVIDIA reference design dual fan control implementations are supported, third party proprietary asynchronous
fan control solutions (e.g. EVGA iCX series asynchronous fans) are not supported and will not be supported in future versions. The
following asynchronous fan control functionality is available:

o Added new “Synchronize fan speeds” button, which is allowing you to switch between synchronous and asynchronours
fan control modes. Please take a note that new fan speed controls are available in v4 skins only, v3 and v2 skins are
deprecated and no longer receive new functionality

o When fan speeds synchronization is enabled, MSI Afterburner’s fan control functionality behaves exactly like in the
previous version, i.e. both fans are running asynchronically in default hardware automatic fan speed control mode but
become linked synchronically if you enable manual or software automatic fan speed control mode

o When fan speeds synchronization is disabled, you may select and adjust each fan speed independently. For software
automatic fan speed control mode independent temperature curves are also adjustable for each fan

New bump for Extreme

Board updated

Oh I haven't even run this one yet since I got my 2080Ti amp extreme
5.4GH z CPU

Board updated