New
#261
I just tried using afterburner instead of FireStorm for my new 2080 Ti Amp Extreme
Afterburner recognizes the Zotac's dual fans(but still only a single controller, which is ok when benchmarking, as I crank my fans to full speed then)
- 14:23:58 Connected to MSI Afterburner control interface v2.3
- 14:24:01 GPU1 : VEN_10DE&DEV_1E07&SUBSYS_451319DA&REV_A1&BUS_1&DEV_0&FN_0
- 14:24:01 Core clock +0MHz
- 14:24:01 Start testing, please wait a few minutes
- 14:29:09 Test completed, confidence level is 90%
- 14:29:25 GPU1 : VEN_10DE&DEV_1E07&SUBSYS_451319DA&REV_A1&BUS_1&DEV_0&FN_0
- 14:29:25 Memory clock +0MHz
- 14:29:25 Overvoltage 100%
- 14:29:25 Power limit 112%
- 14:29:25 Thermal limit 88 °C
- 14:29:25 Fan speed 1 100%
- 14:29:25 Fan speed 2 100%
- 14:29:25 Start scanning, please wait a few minutes
- 14:29:28 Scanning point 1 of 4
- 14:31:58 Scanning point 2 of 4
- 14:34:42 Scanning point 3 of 4
- 14:37:44 Scanning point 4 of 4
- 14:40:01 Scan succeeded, average overclock is 86MHz
- 14:40:01 Dominant limiters
- 14:40:01 No load
- 14:40:01 Overclocked curve exported to MSI Afterburner
The V/F curve it found:
now to test it