Resetting Network Adapter

Matthew Wai · 28 Feb 2020

See the attached file. I ran the .cmd file and got the following:

Code:

Admin State    State          Type             Interface Name
No more data is available.

No more data is available.

Press any key to continue . . .

Try3 · 28 Feb 2020

So, again, What changes did you make to FindString & the processing of the response?

Matthew Wai · 28 Feb 2020

Try3 said:

So, again, What changes did you make to FindString & the processing of the response?

You can see all changes in the attached file.

Try3 said:

there was only one enabled network adapter in the computer.

At the moment, there is only one, and there was only one when I ran your code.

Try3 · 28 Feb 2020

You added the attached file after I had posted my last response.

I think you must be joking. You change a crucial part of a piece of code and you think it is going to run correctly.

That is the end of this exchange.

Denis

Matthew Wai · 28 Feb 2020

The OP has never mentioned "Wi-Fi", so "DisableEnableWiFiCard.bat" could be inapplicable.

jcloversX · 01 Mar 2020

I have been having problems too with My network adapter. I go to device manager> right click on the Ralink adapter listing> choose disable adapter>then enable adapter and jimmy crickets the Wi-Fi icon in my tray shows up again.