Intel DQ57TM Chassis Intrusion Warning


  1. Posts : 59
    Win10
       #1

    Intel DQ57TM Chassis Intrusion Warning


    Just put a system together with the DQ57TM mobo, latest BIOS. Win 10 installed fine, but at each bootup I am confronted with a "WARNING: Chassis Intrusion" message. After a few seconds, the boot proceeds satisfactorily into Windows.

    In the BIOS, Chassis Intrusion is set to Disable, so why am I getting this message, and how do I get rid of it?
      My Computer

  2. Caledon Ken's Avatar
    Posts : 24,395
    Windows 10 Pro x64 Version 2004
       #2

    Hi keithjr.

    This sounds a little crazy. Try enabling and using. If that works leave it. If it doesn't work, then go back to disable.

    When you receive MB did they supply a little jumper for switch?
      My Computer

  3. bobkn's Avatar
    Posts : 3,640
    Win 10 X64 Pro 21H1 19043.964
       #3

    Strange.

    Is anything connected to the chassis intrusion header on the board?
      My Computers


  4. Posts : 59
    Win10
    Thread Starter
       #4

    Nothing connected
    bobkn said:
    Strange.

    Is anything connected to the chassis intrusion header on the board?
      My Computer


  5. Posts : 59
    Win10
    Thread Starter
       #5

    The choices in BIOS are Disable/Log Only/Pause Post.
    With Log only set, the symptoms are unchanged; Pause Post adds the requirement to press continue to complete boot.
    If I add a link to the header with Log Only set, I get two beeps at powerup, and the same error message.
    Caledon Ken said:
    Hi keithjr.

    This sounds a little crazy. Try enabling and using. If that works leave it. If it doesn't work, then go back to disable.

    When you receive MB did they supply a little jumper for switch?
      My Computer

  6. Caledon Ken's Avatar
    Posts : 24,395
    Windows 10 Pro x64 Version 2004
       #6

    Is there a jumper you are supposed to install on board?
      My Computer


  7. Posts : 59
    Win10
    Thread Starter
       #7

    The header is for connection to a microswitch which is normally o/c, but s/c when the chassis cover is removed. So fitting a jumper as I did simulated a genuine chassis intrusion.

    Caledon Ken said:
    Is there a jumper you are supposed to install on board?
      My Computer

  8. Caledon Ken's Avatar
    Posts : 24,395
    Windows 10 Pro x64 Version 2004
       #8

    Well as the board is brand new it sounds defective. Maybe contact vendor and request assistance / RMA.

    If you can't disable in BIOS or short out something is broken, my opinion.
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 08:00.
Find Us




Windows 10 Forums