New
#1
Build 10162, new install: only 1 of 3 monitors work & 2 Win 10 images
I just installed 10162. First try aborted - I was trying to use WiFi and it just didn't play nice, so I finally aborted.
I started over with Ethernet hard-wired in, and it completely installed. But there are two known problems:
- I was running all three monitors (see my system config) with the last four or five releases without problems, with all desktops "extended" on all three devices. Now I just have physical device "1"
- I had to abort my first attempt to load Build 10162. I didn't wipe the hard disk after the failed attempt, so that left a partition with Win 10 partially installed. What is the best way to get rid of that partition? I'll also need to get rid of whatever is in the Boot record so it will not prompt me for the proper version of Windows 10.
Any ideas?