New
#1
stuck at copying windows files 0%
Followed the tutorial, extracted the iso. Ran set up. How long should I let it stay at 0%
Followed the tutorial, extracted the iso. Ran set up. How long should I let it stay at 0%
Try and be patient, I installed 10130 in a dual boot configuration with Win7 on an older Dell laptop (E6400) I was about to force a reboot when it started moving, not sure how long but I was getting impatient.
I'd say wait at least 30 minutes maybe a little longer depending on your box and it's capabilities before doing anything.
Thanks for the info , I waited . no luck . Restarted the install run 100 % , installed quick . Just need to wait for drivers for my video card now :)
Good to hear things are working
The last install I did was 10130 with the iso, (that went a lot faster than an update install on a VM) although there was a point I almost restarted then it picked up and finished installing.
I got a pre-patience step when the msg "Windows can't be installed on this drive" came up and took time to get past. My NE522 did pass that step and is now stuck on copying files. It is a contest now to see if the man can be more patient then the machine!
IT WORKS! In this day of "non-instant means broke" patience still works.
In my case, the running SATA cable was damaged. Which cannot load the HDD after installing start. So, check your cables of HDDs. If they are damaged, buy a new SATA cable.