Had to switch boot drives and how to get programs to run from old driv


  1. Posts : 15
    windows 10
       #1

    Had to switch boot drives and how to get programs to run from old driv


    My C: drive was not running well as a boot drive and I swapped boot drives
    so now it is D: Drive
    both drives are new to windows 10 and do not have programs from it installed.
    is there a way to get access to either drive to install programs.
    I have graphics
    and antivirus software that I would like to get to run at least once if possible.

    Thanks for your reading my post.
      My Computer

  2. NavyLCDR's Avatar
    Posts : 16,184
    Windows 10 Pro
       #2

    Why can't you just run the setup routine for whatever it is you want to install like you normally would?
      My Computer

  3. AddRAM's Avatar
    Posts : 4,380
    Windows 10 Pro x64 21H1
       #3

    You need the program installers.

    Is the drive you swapped in working ok ?

    What is wrong with your C drive ?

    Is it going bad or does it just need a clean install of W10 ?
      My Computers

  4. idgat's Avatar
    Posts : 1,187
    Windows 10 Pro
       #4

    Basic steps (ask if you need more detail)
    You will need an extra external portable USB drive (not a flash drive stick)
    Image the "old" drive with Macrium Reflect (freeware) - save to the external USB drive
    Swap the "old" < > "new" drives over
    Boot from a Macrium boot USB flash drive
    Connect the USB with the image of the old drive
    Restore the image to the "new" drive
    Wipe the old drive so the computer is not confused with2 OSs
      My Computer

  5. Berton's Avatar
    Posts : 11,747
    Win10 Pro Versions 2004 and 2009/20H2, Win10 Pro IP_Dev, Win10 Home 1909
       #5

    A note about progams: Windows-based programs have to be installed in a folder, not just copied, so as to get the Start menu icons, support files copied to the proper places such as in Windows itself and Registry entries made so Windows knows how to run them. The main reason DOS-based programs had an install routine was because their files came compressed on the floppy disks that had to be decompressed into a directory on the HDD.
      My Computers


  6. Posts : 15
    windows 10
    Thread Starter
       #6

    two months ago I was writing about my hdd going down, I was hoping to replace it with a new disk, but that failed.
    so I did a new install of a rather old Hdd and then my now D drive does not load windows 10 has old programs, that I would at least want the codes to take to other computers and install them there.
    It would be nice to use all those programs on both drives, on the old machine too. This is basically a scrapped machine now which I may just use to play videos, but I was hoping to get access to the programs for a short time frame.

    - - - Updated - - -

    both disks were C drives with software attached, but with a new win 10 clean install they cannot run the older programs.
      My Computer



 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 11:29.
Find Us




Windows 10 Forums