Ryzen 5800X Upgrade Build Report & Lessons Learned

  1. EdTittel's Avatar
    Posts : 4,208
    Windows 10
       #1

    Ryzen 5800X Upgrade Build Report & Lessons Learned


    This weekend, my 17-year-old son and I did a partial refresh of an ATX form factor build. We swapped out the old motherboard, CPU, cooler, M.2 NVMe and RAM for a new set of similar components:
    1. Asrock B550 Extreme4 mobo
    2. Ryzen 5800X CPU
    3. 2x32GB DDR4 2600 G.Skill RAM
    4. CoolerMaster 212 Black cooler

    Time to complete build: around 4.5 hours, of which 2 hours for disassembly and cleaning and 2.5 hours for reassembly, build and initial test

    Results: success all the way around. Still need to enable fTPM in BIOS to be Windows 11 ready, but everything else is copascetic for Windows 11 installation.

    Lessons learned:
    1. Had to use Diskpart to set the partition layout to GPT before Windows 10 would install on the drive
    2. Coolermaster 212 is a very TALL cooler so had to remove the side panel case fan to get clearance. May be able to rejigger that, though in a different position. Will check temps first.
    3. Learned the hard way (should have RTFM) to use the M.2.1 slot for the NVMe because using the M.2.2 slot knocks out SATA ports 3, 5 & 6. Making the switch took 5-10 minutes, so no biggie (did have to take out the GTX 1070Ti for room to maneuver
    4. No major issues with drivers or boot-up, once the GPT issue was addressed (Used a Ventoy boot disk with latest Media Creation Tool to grab an ISO for Windows 10 21H1 for our point of departure. 7 or 8 updates from WU were necessary to catch the PC up after that)
    5. The new PCIe Gen3 x4 NVMe driver (Sabrent Rocket Q 2 TB) is very fast, the new build runs about 2x the old one pretty much across the board.

    Overall, very pleased with the results of this partial refresh. I'll spring for a new GPU when the prices come down a bit more, or we get some kind of windfall to justify the nosebleed prices still prevailing. Does pretty well with the 1070 Ti, though.

    --Ed--
      My Computers

  2. Ghot's Avatar
    Posts : 13,057
    Win 10 Home 10.0.19044.1320 (x64) [21H2]
       #2

    Where do you buy that RTFM?
    If the side panel is metal, you could grab some 14 ga. aluminum to plug that hole.
    Another solution would be a thinner fan... something like... a 12mm thick fan as opposed to the std. 25mm.
    Computer Fans and Computer Fan Accessories - FrozenCPU.com



      My Computer

  3. bobkn's Avatar
    Posts : 4,099
    Win 11 X64 Pro 21H2 22000.100
       #3

    If the case is the Rosewill BlackHawk Ultra, you could replace the 230mm side fan with as many as nine 120 mm fans. I doubt that is needed.

    I've gone to using all-in-one liquid coolers rather than large air coolers. I'm currently using a Corsair iCUE H100i RGB PRO XT Liquid CPU Cooler. (Ridiculously long name. And I couldn't care less about the RGB capability, although I haven't turned it off.) No leaks, so far. :-|

    The design of the Blackhawk limits the length of a top mounted cooler, but a 240 mm one is adequate for a 5800X.

    I mention these just in case you feel you haven't dropped enough money on the system, lately.
      My Computers

  4. EdTittel's Avatar
    Posts : 4,208
    Windows 10
    Thread Starter
       #4

    It's an Antec 900 or perhaps 902 case, and it seems to be cooling OK based on the 200mm CPU cooler, the 200 mm top fan, and the three 120 mm fans also in the case: one rear, two at the front of each of the two drive bays. Just got the BIOS flashed and it now passes all tests on the WhyNot11 utility so it should be good to go for 11 when it goes RTFM.

    This is a school/production PC, so it's on 21H1 production build tracking now and will be upgraded when 11 goes public later this year. The Blackhawk is my personal desktop (main daily driver). It has tons of room and would easily accommodate the CoolerMaster 212 black and all of its case fans (of which I count 7 right now). I'm thinking about the same refresh for that machine, too. Pretty impressed, so far.

    Thanks for the input @Ghot and @bobkn.
    --Ed--
      My Computers

  5. bobkn's Avatar
    Posts : 4,099
    Win 11 X64 Pro 21H2 22000.100
       #5

    Sorry to have missed the mark, but I lacked a few details.

    Does Antec use PWM fans yet? That was one of my minor issues with the last Antec case I used.

    That's quite an upgrade for a school machine. I guess the "production" aspect might benefit from 64 GB of RAM.
      My Computers

  6. EdTittel's Avatar
    Posts : 4,208
    Windows 10
    Thread Starter
       #6

    @bobkn: its primary user (my 17-year-old high school senior) has also been known to play some games. The RAM and CPU are helping his user experience, but we still can't afford a state-of-the-art GPU (too expensive, or impossible to get). So yes, it is a pretty formidable "school machine." Thanks for the input.
    --Ed--
      My Computers



 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 14:18.
Find Us




Windows 10 Forums