Windows wants a partition formatted as NTFS

I currently only have a MAC so after building my new computer I made a USB to install Windows 10 Home.
Everything was going fine until I received an error which brought me back to the start.
Once I got back to the page where you select where to install windows, 3 partitions had been made all of them not available to install windows.

I have included a picture of the error message I first received along with the message I get on Drive 0 Partition 1.

I'm not sure if I messed something up with the USB or if there is an easy fix but any help would be greatly appreciated.
Thanks:)

Braeden Kostreb said:

I currently only have a MAC so after building my new computer I made a USB to install Windows 10 Home.
Everything was going fine until I received an error which brought me back to the start.
Once I got back to the page where you select where to install windows, 3 partitions had been made all of them not available to install windows.

I have included a picture of the error message I first received along with the message I get on Drive 0 Partition 1.

I'm not sure if I messed something up with the USB or if there is an easy fix but any help would be greatly appreciated.
Thanks:)

Well of course you cannot install Windows onto the 100MB EFI/System partition. You need to delete all partitions again before trying again. Right next to the "Refresh" button under the error pop up is the "red cross" to delete each and every one so that the entire drive is freed up for Windows install again. What may be happening with your setup is that instead of booting off the new install disk after initial setup your your machine is booting form the USB stick again and you go back to the same setup loop. So watch out and pull the stick when it reboots the first time or hit a boot select F Button on your Keyboard which depends on your machine. Can be F10 or F12 or otherwise and select the disk instead of the USB stick to boot from.

I deleted all the partitions and tried again and immediately got the same error(the first image in my post)
The error comes up as soon as the installation starts at 0%

Yeah, I downloaded the iso and then used MAC terminal to format the USB.
I should also add that i've tried deleting the partitions and trying again a few times with the same result. I also tried installing the 3rd partition which is the 931.4GB one and it says it cannot create or locate a partition.

Can you post screenshot please.

These are the screens I see back to back.

Looks good for now let us know if there is any error message while installation happening.