Hello.
I need urgent help. I cannot install w10 on this pc because I always get an OOBEKeyboard error at one of installation stages. Any ideas?
I have updated BIOS to latest version and have tried changing some bios options/setting defaults etc.
Any help is greatly appreciated.
PS - PC has got only 1GB RAM (ddr2 533 dual channel). I have reserved 16MB for video (integrated vga via nForce 610 (I think) chipset).
I have run sysprep /oobe /reboot but I am still getting oobe errors everywhere.
Are you trying to install 32-bit Windows 10 or 64-bit? Minimum RAM requirement for 64-bit is 2 GB.
I am trying to install x86 version, because PC has got only 1GB RAM. I have not checked hard disk for errors. I am going to check that.
I have just booted W10PXE and it works perfectly. What gives? Is there any way to make w10 boot into safe mode at second stage of installation (OOBE)?
I checked the disk. It's fine. But after retrying first OOBE message it just stalls. I don't know what to do.
Maybe your Windows 10 installation USB flash drive or DVD is bad.
The furthest I could go is OOBESETTINGSMULTIPAGE. I cannot proceed beyond this point. I am going to try v1803 instead of v1809
v1803 installed just fine. Now I am installing v1809 on top of it (fingers crossed).
Amazingly enough v1809 installed fine on top of v1803.
I am now at 17763.195
I have redownloaded w10 iso again from Media Creation Tool just in case, but I have used ISO I previously had (from three different media).
I think it could be some glitch in v1809 installation routines.
Quote