Windows 10: New hardware AHCI driver is rejected by Windows 10 Installation

Page 2 of 2 FirstFirst 12
  1.    17 Jun 2018 #11

    Thank you, and I realized that something was missed. As for not working, this is also true of Linux drivers, especially the ones that depend on the kernel.
      My ComputerSystem Spec

  2. Clintlgm's Avatar
    Posts : 832
    Win 10 pro Upgraded from 8.1
       17 Jun 2018 #12

    I'll take one more shot at this
    You did use MCT to create your install media?
    You need to boot this install media UEFI
    That will take a F Key such as F8, Esc, You need to find out if you don't know as that will bring up a Boot menu, where you will select boot UEFI USB, NOT just the USB but the one that is listed as UEFI USB
    If your BIOS is not set to IRST fine your install drive should show up as a volume to install windows too.
    If your BIOS is set to IRST then you will need to install the RST driver to see your Install drive
    I would assume that by now you have used MCT to create a new Install USB to eliminate any errors that may be on the current install USB.

    The only other thing I can think of is that Gigabyte has some special proprietary device driver that you need to use to install, I don't remember this kind of issue coming up before. UEFI and GPT and installing windows can be tricky if you haven't done this before but not so much once you understand it.
      My ComputersSystem Spec

  3.    17 Jun 2018 #13

    Thanks again, I understood your message and will get back to you in a bit. I am trying now to get the ethernet working in Linux.
      My ComputerSystem Spec


 
Page 2 of 2 FirstFirst 12

Related Threads
How to Enable AHCI in Windows 8 and Windows 10 after Installation AHCI (Advanced Host Controller Interface) makes NCQ (Native Command Queuing) along with hot-plugging or hot swapping through SATA Serial-ATA host controllers possible Usually...
Hello everybody. What started out as a request for guidance ended up with me solving my own problem. Thought I may as well pass on my findings anyway just in case it helps somebody else in the same situation. So over the weekend, through a series...
AHCI installation every time on startup? in Installation and Upgrade
While running Win7 (before upgrading) I was using IDE for disks and manually switched to AHCI and installed it in Windows, but now there is an extra loading screen on every bootup that takes 15-20 secs with "AHCI is installed" at the end, is this...
I have an I5 Ivy-Bridge (B75 chipset) system. Windows 10 is up and running (fresh install) and I've been able to load all but the correct SATA drivers - still using the "Standard" AHCI SATA driver that windows installed. Asus hasn't released a...
Hi All. I would appreciate some help on this one. I found a spare 160GB SATA Drive on which I have decided to install a trial of Win 10 to explore it further for now. The only way that I could get this HD to be seen in the BIOS would be to...

Tags for this Thread

Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 00:07.
Find Us