Windows 10: Can't start off new SSD after cloned from HDD
Can't start off new SSD after cloned from HDD
I bought a new Samsung 250gb 850 evo SSD, and installed it. I do not have a Windows 10 install disk, so I just cloned it from my old HDD to the new SSD. Now I can't start up my computer with that SSD. The error it states says: "Reboot and Select proper Boot device or insert Boot Media in selected Boot device and press a key"
That's if I force it to start from the SSD, otherwise it just automatically goes to my HDD. I can't format the HDD to get windows off of it; because that's the version of windows that I am currently on. Windows along with every single file on my HDD is on my SSD, its just that my SSD is not able to load Windows off of it. If needed any more information, please say so.
Welcome to the forum how did you clone the disk did you clone the complete drive or just some paritions you must do the whole drive your missing the boot sector. Is the drive gpt or mbr?
Did you copy every single partition, excluding any data partitions of course, from the HDD to the SSD.
You have the ability to download the W10 iso file and create an install DVD, why don`t you do that a clean install W10 on your new ssd ?
Windows 10 ISO Download - Windows 10 Forums
or create a flash drive installer, but using the dvd is so much easier.
USB Flash Drive - Create to Install Windows 10 - Windows 10 Forums
Assuming you used Samsung Data Migration to clone the new drive in total, unplug the power cable from your old HDD (when powered down), then power up your computer with only the SSD powered to see if it will then find your SSD from which it can boot. If it works you can then plug your old HDD's power back in and it may continue to boot from the new SSD.
I have W10 which was upgraded from w7 ultimate.
I cloned w10 to another hard drive and now have 2 drives bootable which i can use.
I am going to be buying a new pc without an operating system,before i do can i:
Put one of the drives into this...
I am setting up some computers that has to be locked down tight with local GPO. They are in a non-domain network and is only on the Internet. Can I just clone the drives from one to the others without problems like dual SIDs? Do I need to run...
Got a new Samsung SSD, used the software that came with it to move C to new drive. Ended up with msg "Bootmgr missing". Reinstalled original hard drive, got the same msg. Pulled out SSD, hooked it up to my laptop. Looked at it and the sooftware...
I currently have a cloned 8.1 drive that is unplugged and was done only for back-up before installing 10. Question, since I have no plans to go back to 8.1 I wonder if I should just use it as a test bed for new 10 releases? I guess I could hang on...
I just cloned the new SSD from 128GB to 256GB
And the main partition is not quite exactly the same
I don't have the star screw driver to replace it yet .. so I don't know if it works or not