New
#11
@kitpzyxmsir
UserBenchmark: Intel HD 530 (Desktop Skylake) vs Nvidia GeForce GT 710
UserBenchmark: Intel HD 530 (Desktop Skylake) vs Nvidia GTX 1050-Ti
Personally, I wouldn't buy a GT 710 these days.
The lowest I would go is a GTX 1000 series card. This is the cheapest 1000 series card I can find...
Gigabyte GAMING GeForce GTX 1050 2 GB Video Card (GV-N1050G1 GAMING-2GD) - PCPartPicker
There are two alternatives:
1. Use the DVI-D output with an adapter cable to HDMI.(Cheapest solution).
2. Install a PCI-E Graphics Card with HDMI output. Examples have been mentioned.
I gave the port a squeeze with needlenose pliers, fits more snugly now.if the cable is not absolutely flush, with the slightest movement of the cable or the computer, it loses contact,![]()
Electrically DVI and HDMI are the same for video. All the adapter has to do wire up each end differently. The only real difference is that DVI doesn't support audio while HDMI does. That means if the monitor or TV you connect has speakers then to use them you would have to run a separate audio cable from the computer.
How did you accomplish that?
- - - Updated - - -
[QUOTE=MisterEd;2531217]Electrically DVI and HDMI are the same for video. All the adapter has to do wire up each end differently. The only real difference is that DVI doesn't support audio while HDMI does. That means if the monitor or TV you connect has speakers then to use them you would have to run a separate audio cable from the computer.[/QUOTE @MisterEd,
All I did was replace the HDMI with the DVI. TV/monitor has speakers. Audio works. No separate audio cable.
Did I miss something that will cause a problem elsewhere with some part of the operation?
With needlenose pliers, how else? took the mobo out of the case, and squeezed the top and bottom of the hdmi port together a tiny bit. The bottom bit has a split and will bend up a little.Took a few attempts to get it just right. It is bit fiddly getting one jaw of the plier underneath the bottom lip. If pushed too far, it can be bent out again. Or if there is obvious gap where the bottom bit has separated, squeeze the sides together.
![]()