Page 2 of 14 FirstFirst 123412 ... LastLast
  1.    4 Weeks Ago #11
    Join Date : Oct 2017
    Posts : 454
    Windows 10 Pro 64-bit

    After Chkdsk command finish executing restart your computer to find out if the boot problem resolved if not then i will give you more troubleshooting suggestions.
      My ComputerSystem Spec
  2.    4 Weeks Ago #12
    Join Date : Oct 2017
    Posts : 81
    Windows 10
    Thread Starter

    Still failed. Tried Auto repair, safe mode, system image recovery can't find any image on a Windows recovery driver disk. Not sure where to try next.
      My ComputerSystem Spec
  3.    4 Weeks Ago #13
    Join Date : Oct 2017
    Posts : 454
    Windows 10 Pro 64-bit

    Please boot your computer with Windows Setup Media and from Windows Recovery Environment start the Command Prompt.

    Please type below command into Command Prompt and press Enter key.

    The following command scans integrity of all protected Windows system files and repairs files with problems when possible.

    Code:
    Sfc  /Scannow   /OFFBOOTDIR=D:\   /OFFWINDIR=D:\Windows


    Please replace partition letter D: with Windows installed partition letter. When computer boots into Windows Recovery Environment (WinRE) environment the drive letter assign to Windows partition may not be C: drive letter because Windows 7, 8 , 8.1 and 10 creates a separate system partition when it's installed from scratch. The system partition contains boot files WinRE assigns the system partition the C: drive letter and the Windows installed partition will be assign any other drive letter usually D: drive letter is assign to Windows installed partition. The Bcdedit /enum | find "osdevice" command can be use to find out the drive letter of the Windows installed partition the output of the Bcdedit command is similar to this osdevice partition=D:. The drive letter after partition= is the drive letter of the Windows partition.
      My ComputerSystem Spec
  4.    4 Weeks Ago #14
    Join Date : Oct 2017
    Posts : 81
    Windows 10
    Thread Starter

    I'm in the SFC menu dir now it appears.
      My ComputerSystem Spec
  5.    4 Weeks Ago #15
    Join Date : Oct 2017
    Posts : 81
    Windows 10
    Thread Starter

    Its asking if I want to SCANNOW, VERIFYONLY, SCANFILE, VERIFYFILE, OFFBOOTDIR, or OFFWINDIR
      My ComputerSystem Spec
  6.    4 Weeks Ago #16
    Join Date : Oct 2017
    Posts : 454
    Windows 10 Pro 64-bit

    I'm sorry i don't understand your last post.
    Have you finish executing Sfc command and did Sfc command repaired any damage system files?
      My ComputerSystem Spec
  7.    4 Weeks Ago #17
    Join Date : Oct 2017
    Posts : 81
    Windows 10
    Thread Starter

    It says Windows Resource Protection could not perform the requested operation after the system scan
      My ComputerSystem Spec
  8.    4 Weeks Ago #18
    Join Date : Oct 2017
    Posts : 81
    Windows 10
    Thread Starter

    I'll have to pick this up again tomorrow. I have to close my shop down for now. I do appreciate you're help. It has been a most perplexing problem!
      My ComputerSystem Spec
  9.    4 Weeks Ago #19
    Join Date : Oct 2017
    Posts : 454
    Windows 10 Pro 64-bit

    Make sure you type the command correctly and make sure you have replace D: drive letter with Windows installed drive letter.
    You can use Dir command to list content of the any partition to list C: partition content execute Dir C:\ command.
      My ComputerSystem Spec
  10.    4 Weeks Ago #20
    Join Date : Oct 2017
    Posts : 454
    Windows 10 Pro 64-bit

    Quote Originally Posted by Kurdatz View Post
    I'll have to pick this up again tomorrow. I have to close my shop down for now. I do appreciate you're help. It has been a most perplexing problem!
    See you tomorrow!
      My ComputerSystem Spec

 
Page 2 of 14 FirstFirst 123412 ... LastLast


Similar Threads
Thread Forum
Preparing automatic repair - stuck - Desktop won't load Windows, stuck
Hello everyone, hope some experts can read and maybe help me out. I am frustrated. I have a problem which I tried to research first in many forums,videos, etc., and now I am exhausted after a couple of weeks tryingto find a solution.I bought at...
General Support
Win10 cannot load, stuck in recovery mode with various error codes.
Hello, I have a Samsung series 7 from 2012 that originally came with windows 7 and I upgraded it around 9 months to windows 10. One day my laptop was fine, the next it was stuck in the recovery screen with I believe a message of 0xc00000e9....
General Support
Used option to completely reset pc. Stuck at 99% for an hour
Should I be worried. I upgraded from Win 7. It took me to the welcome screen and when I typed in my password it would just hang. Then go black and reboot. So I pressed ctrl alt delete and options came up. I decided to just reinstall basically...
Installation and Upgrade
Stuck on black screen, large cursor arrow and windows will not load
Hello, I recently started getting a black screen when trying to turn on my laptop, a Sony Vaio running Windows 10. I am unable to download the DM log collector tool since I cannot use my computer at all. It stays on the black screen even if I let it...
BSOD Crashes and Debugging
Windows 10 Stuck in Load Screen BEGGING FOR HELP
I had a dual monitor set up and one day both monitors froze and the computer shut itself down. Ever since, when turning on the PC this is as far as I can get: IMG 5324 - YouTube . This cycles forever and does not progress to any other screen...
General Support
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 02:59.
Find Us
Twitter Facebook Google+ Ten Forums iOS App Ten Forums Android App



Windows 10 Forums