New
#1
Windows will not boot after using Driver Update Software
Good evening everyone,
I decided to check my drivers today to see if needed any updates using BitDriver software. I updated and restarted like it instructed and at the MSI motherboard logo, it stated that it was finishing the update, then it restarted. Once it restarted no logo appear and no signal is being sent to my monitor.
I have tried to boot into safe mode, use a rebootable hard drive, however it does not seem to be recognizing any commands. I also remove the cmos battery for five minutes timed and still no luck.
Thanks in advance.
- - - Updated - - -
Update. I am still continuing to try and work on this.
What I notice: my motherboard normally shows the temperature of my cpu in the digital display towards the left. However, it only shows 00 now. Hopefully this helps clue into the problem