Hello There Everyone.
I shutdown my pc yesterday after work after 12 hours i open it but i am stuck with black screen. I tried my steps to open it but it dosen't work.
Steps i did
*i tried to startup repair on advance menu
*i have reset the pc ( its says problem occured)
*i have Uninstalled recent update.
My pc specs
*Acer Veriton
*64 bit
*windows 10
Please help me to solve out
Last edited by bdxoul; 27 Nov 2019 at 23:04. Reason: specs
Can you boot into Safe Mode?
How canni boot to safe mode?
-thanks
- - - Updated - - -
yes i tried booting with safe mode +networking
but it sgows following error
lohonUi. exe system error
the system dedect5an overrun of stack based buffer in this application. the overrun cild potentially allow a user a maliciously user 1
Please boot your computer with Windows Setup Media and from Windows Recovery Environment start the Command Prompt.
Please type below command into Command Prompt and press Enter key.
The following command scans integrity of all protected Windows system files and repairs files with problems when possible.
Code:Sfc /Scannow /OFFBOOTDIR=D:\ /OFFWINDIR=D:\Windows
Please replace partition letter D: with Windows installed partition letter. When computer boots into Windows Recovery Environment (WinRE) environment the drive letter assign to Windows partition may not be C: drive letter because Windows 7, 8 , 8.1 and 10 creates a separate system partition when it's installed from scratch. The system partition contains boot files WinRE assigns the system partition the C: drive letter and the Windows installed partition will be assign any other drive letter usually D: drive letter is assign to Windows installed partition. The Bcdedit /enum | find "osdevice" command can be use to find out the drive letter of the Windows installed partition the output of the Bcdedit command is similar to this osdevice partition=D:. The drive letter after partition= is the drive letter of the Windows partition.
You can go to task manager and start explorer.exe by going to File > Run new task. Should be a temporary fix until you get the problem fixed.
This can sometimes happen if you try and take ownership of the OS. Trusted Installer has a paddy fit and then, 'The computer says no'. Removing any 'NT Authority' in users and groups will have the same effect.
Regarding the 'user 1'. This is something to try. Go into BIOS and see what the memory profile settings are. If you are running any XMP profile, remove it and just run memory on Auto or Manual.
Ive tried many ways to get out of the black screen. I think its your user account association which is missing and needs to be replaced. Good luck and hope you manage to fix it
Quote