Problems With Start Up in Windows 10 Solved

Page 1 of 2 12 LastLast
  1.    1 Week Ago #1

    Problems With Start Up in Windows 10


    I have an issue that occurs when I press the "on" switch for a cold start. The first time, I get the HP logo but no spinning dots. Then if I power down and press on again, I get the HP and spinning dots. Windows 10 starts but much slower than normal. After that, things seem to run normally.

    I tried to do a system image restore, but got a message that said the Recovery Partition needed to be formatted. That didn't sound too good to me.

    I am currently on version 1809 11763.316.

    Will a repair/install correct this problem? If so, can you give me the steps to download the ISO and conduct the repair/install? I did one a while back, but a refresher would certainly help.

    Thanks
      My ComputerSystem Spec

  2.    1 Week Ago #2

    People have resolved this kind of problem by disabling fast startup. Could be worth trying.

    I tried to do a system image restore
    - sorry, which form of restore did you mean, and by what means?

    For reference- details about downloading iso's and performing an in-place upgrade repair install are in the (searchable) Tutorial section. In addition to MS media creation tool (Google it) there is an iso downloader tool in the 3rd post in the thread on Kyhi's boot disk at the top of the Software and Apps section.
      My ComputersSystem Spec

  3.    1 Week Ago #3

    I tried the system image restore Windows version. I have disabled "fast startup" and will test that shortly ...
      My ComputerSystem Spec

  4.    1 Week Ago #4

    Click image for larger version. 

Name:	1.jpg 
Views:	1 
Size:	100.3 KB 
ID:	224041

    Disk imaging using a 3rd party tool such as Macrium Reflect (free) is recommended here time and again. Even MS has advised 3rd party tools are preferable.
      My ComputersSystem Spec


  5. Posts : 23,933
    windows 10 professional version 1607 build 14393.969 64 bit
       1 Week Ago #5

    Most HP computers come with default BIOS UEFI hardware diagnostics that can test Drive and RAM.
    If you had at any time updated the firmware to a newer version there are extensive, component, and loop until failure tests.

    If the computer has more than one disk remove the non-Windows disk for the next step.

    Power on the notebook and repetitively click the F2 key to open the BIOS UEFI diagnostics.
    Perform the available tests.
    Use a camera or smartphone camera to take a picture of the results and post an image into the thread.

    How to Upload and Post Screenshots and Files at Ten Forums | Tutorials
      My ComputerSystem Spec

  6. Kari's Avatar
    Posts : 15,555
    Windows 10 Pro
       1 Week Ago #6

    TexasBandit said: View Post
    I have an issue that occurs when I press the "on" switch for a cold start. The first time, I get the HP logo but no spinning dots. Then if I power down and press on again, I get the HP and spinning dots.
    I am a fan of HP laptops and desktops. For the most, I am and have been really satisfied, but they have their faults, too.

    My current HP ProBook 470 G5 laptop for instance, it occasionally acts as you have described. A cold boot, I might have only the HP logo showing for a minute or longer, then suddenly the laptop boots normally.

    My suggestion is to wait. Let the device stay turned on, do not press the power button in at least a minute or two, and see if it finally starts.

    Kari
      My ComputerSystem Spec

  7.    1 Week Ago #7

    Disabling Fast Startup solved the startup problem. If I enable Fast Startup, the problem returns. This only started after the last update fiasco from Microsoft.

    zbook: Thanks for the reply, but my system isn't that complex. I have not updated the firmware.

    Kari: I have tried leaving it on with just the HP logo for quite a while. Nothing happened.

    Dalchina: I am going to install Macrium Free and use it from now on.

    Thanks guys for the responses ...
      My ComputerSystem Spec

  8.    1 Week Ago #8

    That's kind of good news- but it's a workaround of course. However there are about 3 other similar recent reports that I've seen.
      My ComputersSystem Spec


  9. Posts : 23,933
    windows 10 professional version 1607 build 14393.969 64 bit
       1 Week Ago #9

    Glad to see the problem fixed.

    If you perform preventative maintenance these are some steps you can perform:

    1) Download and install HP Diagnostics Windows: (right upper area of this link)
    HP PC Hardware Diagnostics | HP® Official Site

    2) Open HP PC Hardware Diagnostics Windows version 1.5.4
    Click system tests > click system extensive test > click run once (run this overnight and check the results in the AM)

    3) If there were any problems detected then run the component tests as needed.

    4) This should test most of the hardware on the computer except for RAM.
    The RAM testing is available using the HP BIOS UEFI diagnostics.

    5) Download and install if not already installed: HP Support Assistant:
    Driver - HP ENVY 17t-j100 Quad Edition CTO Notebook PC | HP® Customer Support

    6) Run the software to find any drivers or BIOS that may need to be updated > update drivers and BIOS

    7) Open administrative command prompt and type or copy and paste:
    8) sfc /scannow
    9) dism /online /cleanup-image /restorehealth
    10) chkdsk /scan
    11) When these have completed > right click on the top bar or title bar of the administrative command prompt box > left click on edit then select all > right click on the top bar again > left click on edit then copy > paste into the thread
      My ComputerSystem Spec

  10.    1 Week Ago #10

    I do perform preventative maintenance, and thank you zbook for the advice. I just ran Macrium backup, and it reportied bad MFT segments or something like that. Macrium suggested chkdsk /r , and I am going to do that right now. Thanks again ...
      My ComputerSystem Spec


 
Page 1 of 2 12 LastLast

Related Threads
I had many problems with the Windows Start Menu and Cortana not working at all 3 days ago and I have resorted to Resetting my PC after many attempts of trying to fix the problem by following google and youtube guides. Everything was working fine...
I'm probably like most people - able to solve the seemingly endless minor windows problems that arise after a bit of google searching on forums. However at the moment I've got two problems that I just can't fix despite trying every solution I could...
I was running along for 6-7 months before my start button failed me. About a week or two later the taskbar became very slow or unresponsive. Then the context menu is so very slow that I do everything to avoid right click. Now this past week I've...
I installed windows 10 a few months ago and I was using it for about 4 weeks, then one day everything on my task bar (including start menu, cortana, calendar volume) stopped responding, only my opened windows worked (Chrome, skype) and there was no...
Windows 10 start menu problems in General Support
Downloaded W10 last night (from win 8.1) and right out of the gate I am having problems with the start menu. 1) can't get live tiles to work on tiles in the start menu 2) some are garyed out 3) I remember seeing extra large app sizes in...
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

ę Designer Media Ltd
All times are GMT -5. The time now is 00:52.
Find Us