Will only boot in safe mode and with driver signature enforcement off

My laptop would not boot and the automatic repair never worked. tried about 15 times but just comes back with an error and to check CBS log. I tried many things but the only thing that has worked is to Disable driver signature enforcement" This allows it to boot but only into safe mode.

I have tried sfc /scannow but that fails.
Tried the DISM command and that too failed.

before I managed to get it to boot up, I checked the CBS log file and it mentioned a problem with bootrecs.dll

Can't do system Restore.
Can't do reset windows.

Can anyone help? It's driving me mad.

Hi. Thanks but I doubt the repair tool would fix it. I wouldn't know where to start anyway.

Hi 1974darrenh

Boot your Windows into Safe Mode and execute below commands:

Code:

Sfc /scannow

Findstr /c:"[SR]"  "C:\WINDOWS\Logs\CBS\CBS.log" > %UserProfile%\Desktop\Cbs.txt

Make sure to execute the Findstr command after SFC command completed and attached the Cbs.txt file that will be created on your Desktop to your next post.

Also open Device Manager by typing Devmgmt.msc into Start Menu and from Device Manager uninstall all newly and faulty device drivers.

Hi.

Thanks for your help.

I have done as you have asked. The initial sfc /scannow came back as "Windows resource protection did not find any integrity violations"

I did the second command and have attached the result to this post.

I looked in device manager and couldn't find any recent or faulty drivers. (Surely tho, if it boots in safe mode and not normal mode, then it must be a driver?)

However I still have problems. When I boot the computer, it fails after 3 seconds and goes into a boot loop 3 times until the startup repair starts up, it then attempts repair but cannot fix. I then boot it into safe mode and it starts up perfectly with no problems so my problem is, getting out of safe mode and back into normal mode

I used "Sigverif" and it has come back with 42 unsigned drivers.

Sigverif attachment

1) Open the HP website > support and drivers > enter the product or serial number or model > select the operating system > view drivers > post a URL or hyperlink into the thread

2) When the full HP model is available please update the system specs:
System Specs - Fill in at Ten Forums | Windows 10 Tutorials
In the left corner below in your post you find 'My System Specs'.
After clicking it you can find a link a little below that says 'Update your System Spec', click on this link to get to the page where you can fill in your system specs.
System Info - See Your System Specs - Windows 7 Help Forums

Include PSU. cooler, case, peripherals and anything attached to the computer by wired or wireless (mouse, keyboard, headset, printer, xbox, USB wireless network card, etc.)

3) There are two log collectors: DM and BETA
Run the beta log collector near the bottom of this webpage and post a zip into this thread.
BSOD - Posting Instructions - Windows 10 Forums

This seems easier.

In the "My Computer" section please update to display:

HP Pavilion g6-1310ea Notebook PC

The computer manufacturer supported drivers ended with Windows 8.
The last BIOS update was in 2013.

When available please post the beta log collector zip into this thread for troubleshooting.