MicroSD Card drive cant open and cant format

Hey guys,

I have ADATA MicroSD Card 64GB and it was working fine yesterday and I decided to format it. It does format good but I run quick format again and than its showing me the error below.



Regards.

Try formatting it with HP USB Disk Storage Format Tool 2.2.3 http://www.softpedia.com/get/System/...mat-Tool.shtml . (Right click on the HPUSBDisk.exe and run as administrator. Make sure you remove/plug out all other USB drives to prevent accidentally formatting the other drives.)

Hi there

Try the following

1) eject and re-insert card.

Iif it's in an adapter ensure card is correctly in place and read only switch not enabled (usually a tiny little slider on the adapter --e.g the pny ones).

2) run cmd in admin mode

diskpart
list disk

then you should see the micro sd card as a disk -- it will probably show as 59 GB for 64GB card or similar

continue with the command

select disk n where n is the disk nr

create partition primary
format fs=ntfs quick
active
assign
exit

Then it should be working again.

Cheers
jimbo

jumanji said:

Try formatting it with HP USB Disk Storage Format Tool 2.2.3 http://www.softpedia.com/get/System/...mat-Tool.shtml . (Right click on the HPUSBDisk.exe and run as administrator. Make sure you remove/plug out all other USB drives to prevent accidentally formatting the other drives.)

Its saying this error:

jimbo45 said:

Hi there

Try the following

1) eject and re-insert card.

Iif it's in an adapter ensure card is correctly in place and read only switch not enabled (usually a tiny little slider on the adapter --e.g the pny ones).

2) run cmd in admin mode

diskpart
list disk

then you should see the micro sd card as a disk -- it will probably show as 59 GB for 64GB card or similar

continue with the command

select disk n where n is the disk nr

create partition primary
format fs=ntfs quick
active
assign
exit

Then it should be working again.

Cheers
jimbo

Error:

Try Option Two from this tutorial Enable or Disable Disk Write Protection in Windows - Windows 10 Hardware Drivers Tutorials

ZyKLon said:

Try Option Two from this tutorial Enable or Disable Disk Write Protection in Windows - Windows 10 Hardware Drivers Tutorials

After doing Option Two from the given tutorial I got this error when I try to format sd card

Do you tried this?
Open a command prompt AS ADMIN
type DISKPART press <enter>
type LIST VOLUME press <enter>
type SELECT VOLUME X, where X is the volume number you want to remove the write protect from.
type ATTRIBUTES DISK CLEAR READONLY press <enter>
you will see a prompt that the write protect has been removed
type EXIT press <enter>

ZyKLon said:

Do you tried this?
Open a command prompt AS ADMIN
type DISKPART press <enter>
type LIST VOLUME press <enter>
type SELECT VOLUME X, where X is the volume number you want to remove the write protect from.
type ATTRIBUTES DISK CLEAR READONLY press <enter>
you will see a prompt that the write protect has been removed
type EXIT press <enter>

Done that also but cant foramt it.

Do you have access to another computer with windows 7?