Windows 10: ICH10R support? cannot install any driver other than generic
ICH10R support? cannot install any driver other than generic
Dell Studio XPS 9100.. presumably has [according to Hdw ID] ICH10R controller
I have tried everything Intel has for the part, but will not install.
stuck with the generic Microsoft AHCI driver
I am using a Samsung evo 840 ssd if it matters
can anyone help?
Have you tried any of the files available through Dell's support site using your Service Tag?
Should be within your chipset drivers for the model ... Don't look specifically for ICH10R, you won't find that listed ...
The Studio XPS 9100 uses the Intel X58 chipset.
I don't know of any better drivers for that than those included with Windows 10.
You may find post #3 at this site illuminating:
Intel Rapid Storage and X58 - Platform not supported - AnandTech Forums
The link that Bobkn gave above is a good one, Fernando1 in that thread knows what he is talking about , I am using his modified drivers 22.214.171.1246 on my X58 but I am using Raid0 , though my Evo 850 isn't in the Raid Array.
Fernando's Main site is here
this is the thread with his modified Drivers ....make sure to install the certificate in the zip 1st , RC>install
OK. Win 10 goes generic ancient Microsoft AHCI driver. I doubt it allows full use of 6gbs SSD
Benchmark the SSD and find out. Windows 10 was created far enough in the past that it could easily include proper drivers.
I'd be more worried as to why I couldn't install the straight-from-Intel drivers.
Fernando's Modified Drivers will install on all fairly modern chipsets , that is why he modified it , as some Manufacturers use cheaper chipset versions without all the features and thus Intel's own driver won't install, for eg. there are at least 4 versions of the ICH10 , and I am using his Modded+signed Intel RST drivers v126.96.36.1996 Driver on an old P45 Board for the ICH9R too as there are no newer Intel Drivers that would install, I use it for the ICH10 (X58) and on my X99 Board too..
With your Hardware ID from Device Manager you can check your actual Chipset on Fernando's list here :
Modded Page again....do some reading....
you're right; i should have checked Fernando's site first. He usually has the right answer.
He knows his stuff and hasn't put me wrong yet , and his Site was where I finally worked out why Win10 was having so many Issues on my older Motherboards with Raid. ( the Chipsets aren't supported properly in Raid by the Driver included with Win10 when you install it)
This post is good for his recommended Drivers , at the bottom of the 1st Post is a Table of what he recommends for each Chipset
Last edited by Kbird; 10 Jun 2016 at 13:31.
I have an x58 motherboard witch have an ich10 r sata controller.
Can u tell me witch is the max safe voltage fo ich10 r (southbridge)?
I searched in intel site but i coulden find it.
I am an 82 year young person. I have windows 10 on a Lenova desktop computer. I just downloaded Driver Support software. In my control Panel, I list realtek. Is this a redundant system with Driver Support? If so , can I just delete realtek?? Thank...
I have Lenovo G500, and I would like to do clean installation of Windows 10 (I prefer so rather than upgrade)
According to this thread in Lenovo:
Lenovo G500 WIndows 10 drivers - Lenovo Community
This laptop may have issues with Windows 10...
I recently bought a TP LINK TF-3200 card because my Lan port got fried :P. But, it id getting detected but is not working as I am not able to find new drivers for it. Need help urgently please.
I'm curious, I might have to try this on an extra partition...
My computer is fully activated on Pro version. I've also done a clean install after the upgrade and activated immediately just fine.
So, let's say I bungled and clean installed...