Windows 10: Windows 10 Disk SMART error pop up warnings.

Page 2 of 2 FirstFirst 12

  1. Posts : 3,835
    Mac OS Sierra
       20 May 2016 #11

    Never seen Windows ever pop up stating that the hard drive was bad. Sounds like third party software software watching the hard drive.

    There really is no need for constant monitoring of the Hard drive.
      My ComputerSystem Spec

  2.    20 May 2016 #12

    @tweakit
    You could just download the Free version of Speccy from Piriform. It shows you the current status of your smart drive.
    https://www.piriform.com/speccy/download
    Does not report automatically thou
      My ComputersSystem Spec


  3. Posts : 53
    Windows 10 Pro 64 bit and Windows 7 pro 64
    Thread Starter
       20 May 2016 #13

    Yes I have CrystalDiskInfo which reports all disk SMART data but it too is not automatic. You must launch it to find out if anything is degraded. This is where the windows built in diagnostics is nice, as it only bothers you when a SMART value has dropped below the threshold value which signals an imminent problem.
      My ComputerSystem Spec


 
Page 2 of 2 FirstFirst 12

Related Threads
Hdd smart error in Drivers and Hardware
I had a laptop with a hitachi disk hts545050A7E380 of 500gbyte with a relocation sector count of 20010 (hex). I have changed the disk with a new hts545050A7E380 and when i start the laptop to restore the image i get the message from the pc (not...
RAID 0 SSD Windows 10 Disk Read Error in Installation and Upgrade
I bought two new SSDs to be used in a RAID 0 configuration with a Dell 9020 under Windows 10. Before the drives I arrived I configured two old HDDs in RAID 0 and installed Windows 10 as a clean install. This worked perfectly. Once the new...
During Windows backup, which wants to backup the 'C' drive and my games drive 'E' (for some reason), I get the following error message after the 'C' backup has completed but not the 'E': 'The backup operation that started at...
I am on my 4th SSD in my Windows 10 laptop that has been getting SMART error 2000-0151. We have replaced the motherboard, the SSD, and the connector cable between the SSD and motherboard. One thing is that I've been using Macrium Reflect to clone...
So, after about 2 weeks of experiencing Windows 10 I've decided to revert back to Windows 8.1, since I was more experienced at it. So I followed every step to downgrade the system, waited for about a few hours, then I noticed that when Windows...

Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 11:01.
Find Us