I have read all the tips about installing my Saitek Flight Yoke in Win 10 (and P3D), but my yoke doesn´t even show up in the device manager. Installer from Saitek stops where the yoke shall be conneced but nothing happens when I do.
Jack
the Swede in Spain
Your My System Specs gives no useful information but how old is the computer? How old is the Flight Yoke? Could it be the Yoke is plugged into a USB 3.0 port [on newer computers]? I have seen numerous times when older hardware such as Thumb drives and printers can't work properly on USB 3.0 ports but are fine on USB 2.0 ports on the same computer even though USB 3.0 is supposed to be backward compatible with USB 2.0. I have a couple of 4GB Thumb drives from several years ago that fit that scenario.
No it´s installed into a 2.0 slot. It did work perfectly until I had do do a system re-install yesterday.
Quote