New
#21
Hello, thank you all for the many replies!
I have not yet configured anything, but here are some questions/comments.
- The reason why I pasted that information from my registry (stupidly typing it manually), my point was to show you how Parallels does it, and that this method works flawlessly. If the information that I gave there does not suffice, please give me instructions and I will follow them. However also note that the Parallels method is obviously integrated in the whole VM, so perhaps something is happening there that cannot be achieved outside of the Parallels VM Software logic. (But like I said, these folders are accesible via network, and via the navigation pane special folders too)
- Concerning the Winaero method, since I want to add a NETWORK folder (the files on MacOS accessed via network from within the VM), I encounter two questions:
a) It was mentioned earlier that the Winaerao method seems to perform some aggressive locking attemts. I don't know if that might cause issues with the VM / MacOS host system where the target is / network (it uses prlsf file system).
b) when I go to Winaero and attempt to add one of the macos network folders, I get a banner in the file/folder select dialogue. "network detection and file sharing are deactivated (I don't understand why, because I can regularly access them in file explorer). network computers and - devices are not visible. klick here to change...."
then i get:
"shall network detection and file sharing be activated for all public networks?
no, transform the network to a private network
yes, activate for all public networks"
I don't know if I will mess up by choosing any of these.
please note that I translated from German.