New
#2061
That's not a bad price, and USB 3 from the get go.
My next decision is whether or not to, and how many holes, I drill in my nice new official Pi Foundation Pi 3B case? It's identical to the white/red one I sold you, only all black, and the light pipes on the correct side for the 3B. I bought it a while back knowing I was going to buy another 3B at some point. I know it's going to get hot inside, it has no cooling vents in it at all. I may just leave the top open and not mount the top most cover. Holes in the very bottom won't show but the board will block those and I don't think much air will circulate. I'm pretty sure I'm going to have to put a couple of small holes in each of those side pieces. The one that's just blank for sure. I think I'll tape a piece of graph paper over it so they all line up nicely. I'll use my dremel with a small drill bit too for better control. I'll turn the speed way down. I ordered a couple of the tall heat sinks with that last order so one of those should help. I also ordered a couple of the smaller (not so tall) ones for my Zero. If the tall one is too tall I use one of those instead. I'm pretty sure the taller one will fit though. That or cut a square hole in the top cover and let it stick out the top. I'll sort it all out when I have all the parts in front of me.