New
#571
too early in the day for me to take that all in ,my memory issue isn't getting any better ,I have to takes notes!
I have a pi zeroW on the way .,, will give the motioneye a go when it gets here .
too early in the day for me to take that all in ,my memory issue isn't getting any better ,I have to takes notes!
I have a pi zeroW on the way .,, will give the motioneye a go when it gets here .
Overclock that new Pizero 2w beast ,lol
Raspberry Pi Zero 2 W Overclocking - Boost Up To 1.2GHz,... - Hackster.io
You should get close to 3A+ performance or match it if you can reach 1.4GHz. Your going to want to add a heatsink so it doesn't throttle the clock back on you.
Pi 3A+
Broadcom BCM2837B0, Cortex-A53 (ARMv8) 64-bit SoC @ 1.4GHz
512MB LPDDR2 SDRAM
Pi Zero 2 W
Broadcom BCM2835 Arm v7 Quad Core Arm Cortex A53 running at 1 GHz
512MB LPDDR2 SDRAM
7 Pi's and 1 PICO running and in use as I type this post.
Last edited by alphanumeric; 04 Dec 2021 at 06:42.
I have to admit,I have one running right now ,my newest Pi4 [THAT I GOT FOR CHRISTMAS LAST YEAR .]is setup to a monitor and its wired keyboard and mouse on the desk, The stiff cables on the mouse and keyboard drive me nuts ,and the mouse wire is way to long ,I have been working on painting and setting up my PI Desk and shelves ,we have a long winter ahead, will get things done eventually ... lol , my new pi zero was projected to arrive yesterday,but a check of the Canada Post tracking it only made it to Sydney ..
Last edited by caperjack; 06 Dec 2021 at 16:49.
Got my New Pi Zero 2 today ,going to run it soon for the first time , had to make supper first ...then solder on a header . got some new soldering stuff with the order too.
finally have it running, was just trying it with a sdcard from another pi and sdcards i had loaded and ready to use , ,was getting a long list of usb errors ,I have never see that before on any Pi,, so i took a new sdcard and used Pi imager V 1.6 ,installed, Pi OS 32bit and that loaded up .good to go , for tomorrow ,I'm done for the night
The Zero 2 W has a custom SOC, that needs custom firmware. It's new based on old, lol. The ram is beside the processor not on top like the Pi Zero POP layout. And all in the one package not two separate chips like a 3B or 4B. Buster will run on it, and Bullseye of course. I doubt Jessie will run.
Doing an apt update, apt full-upgrade before moving the SD card to the Zero 2 W will likely get you a working system.