BSOD When Connected to the Internet

There's either a compatibility issue with the drivers or the USB itself is faulty, in either way I would recommend replacement for a USB network adapter that is compatible wih Windows 10.

Thanks for the advice but the current USB adapter has been functioning well since I've upgraded to Windows 10 quite a while ago, till now, unfortunately. I've tried using a different USB adapter that functions fine on another Windows 10 system and it has also resulted in the same "KMODE EXCEPTION NOT HANDLED" BSOD. Also, while installing the wireless utility for the adapter, the computer resulted in a BSOD with "CRITICAL PROCESS DIED." Attachment 165371

Did you use the other USB adapter in the same USB port?
Did you try different USB ports?

Please run the following test with NO internet connection.

Diagnostic Test

 DRIVER VERIFIER

   Warning

Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.

Please follow this tutorial to run driver verifier.

Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

   Note

Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.

After about 38 hours, I came back to my PC to find it in the "looks like your PC did not start correctly" screen which happens after a few crashes. After booting into safe mode and rebooting normally, it is back to normal (as in it hasn't crashed). I haven't yet connected to a network.

Update: While creating a system restore point, the PC crashes a few seconds into the process with "CRITICAL PROCESS DIED." Here is the updated log: Attachment 166018

1 of the crashes shows the display driver, but another shows something entirely different.
The other one shows no driver, but it does show an unknown error code which is undocumented and there are roughly 15000-20000 error codes.

When I asked you how many times a BSOD occurs when you connect to the internet, that was because I was wondering what the next best step was, either a memory test or continuing with drivers. Now, with the 0xEF that is often caused by RAM and HDD, a memory test needs to be performed. Please perform the below linked test, in case you have something important to do I would recommend to remove 1 stick and perform the test overnight, do this twice according to the instructions and let me know what the results are.

Diagnostic Test

 RAM TEST

Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

   Note

MemTest86+ needs to be run for at least 8 complete passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.

Make a photo of the result and post it.

Addition:
If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
If errors show up and you see them a lot later, no problem, the errors don't affect the test.

Post a photo of the test, as requested, please.