BSOD when using p3d v4 flight simulator no error codes

axe0 said:

As requested, please update your system specifications and specify the models.

Hi, I have updated the system spec, not sure what else I can tell you with regards models?

My computer is not a dell or packard bell etc, It was built to my spec 2 years ago if that help?

Crashed again!
I can fly for about 30 mins and then it crashes.
I am thinking either psu or graphics crd?
I am stress testing my cpu ATM

Attachment 154827

Just to update the thread in case anybody else has issues.
It seems the Alabeo pa44 siminole is crashing in p3d v4.
I have just flown the same route in the A2A C172 with no problems at all.

Crashed again!
If somebody could please have a look and maybe give me some sort if indication as to what is causing the crashes I would be most grateful.

Attachment 156741

Did it crash with a BSOD?

There is no sign of a crash dump file or log of any recent BSOD event.

philc43 said:

Did it crash with a BSOD?

There is no sign of a crash dump file or log of any recent BSOD event.

Hi, thanks for your reply.
No it went off with a black screen and rebooted.

Open administrative command prompt and run chkdsk /x /f /r on each drive.
The test may take many hours so plan to run overnight.

Use the information in this link to find the chkdsk /x /f /r report in the event.vwr
Read Chkdsk Log in Event Viewer in Windows 10 Performance Maintenance Tutorials
Please post the results into the thread.


Run HDTune on every drive:
http://www.hdtune.com/
to check the health,
scan for errors, no quick scan but full scan
run a benchmark.


It may take some time, but please take the time you need to perform it properly.
When above is done please make screenshots of the following
the health,
the error scan,
the benchmark incl. following
transfer rate,
access time,
burst rate,
cpu usage.
Take Screenshot in Windows 10 General Tips Tutorials

For each drive please post images of each of these scans: Health, full Error scan, and benchmarks.

zbook said:

Open administrative command prompt and run chkdsk /x /f /r on each drive.
The test may take many hours so plan to run overnight.

Use the information in this link to find the chkdsk /x /f /r report in the event.vwr
Read Chkdsk Log in Event Viewer in Windows 10 Performance Maintenance Tutorials
Please post the results into the thread.


Run HDTune on every drive:
http://www.hdtune.com/
to check the health,
scan for errors, no quick scan but full scan
run a benchmark.


It may take some time, but please take the time you need to perform it properly.
When above is done please make screenshots of the following
the health,
the error scan,
the benchmark incl. following
transfer rate,
access time,
burst rate,
cpu usage.
Take Screenshot in Windows 10 General Tips Tutorials

For each drive please post images of each of these scans: Health, full Error scan, and benchmarks.

Thank you for posting this, I will do as stated and update the thread. It has not black screened for a while now but there is something causing it to just reeboot without warning.