New
#1
Windows 10, BSOD, System Thread Handler exception : UNABLE SAFE MODE
Hiya everyone, So basically here is the situation... I'm at the point where I don't know what else to do other than RE-INSTALL .. which is a pain in the @^& if I have to reinstall and reconfigure all the software that is installed already..... I'd LOVE to be able to simply get back in to windows and get this sorted out..
Here's what i've done so far.. Please help if any of ya can..!
- I've turned the computer off, turned it on and instant BSOD (system thread handler exception ) error with NO specific driver etc information which results in the computer need to restart (type of message)
- So I reboot, it goes into it's auto diagnostic serious of garbage and then basically is unable to fix the error.
- So I try all the normal steps of trying to get safe mode running, .. in the end not able..
- I Do a memory test, takes like 24 hours to complete (32 gigs of ram) no problem..
- I again try safe mode via manual means (ie,. BCDedit bla bla legacy-standard-legacy) still NOT able to get into safe mode..
- SO basically EVERY reboot and attempt to NORMALLY run windows OR Safe Mode results in BSOD and unable to get into windows.
- I've tried MULTIPLE restore points from within the auto-diagnostic boot up screens.. ALL failed.
- I've gone into Command prompt and ran checkdisk etc.. and NO problems at all on C: (my only drive)
- I've gone into bios verified ALL overclocking everything is set to standard (ie, not overclocked and system stable)
- I've verified all fans and water cooling is CLEAR of dust and other garbage that could cause heating..
- System temp is 30 C unloaded... no isssues here..
My system is a mini super computer basically lol.. I built it and it's for VR use and creation and has no hardware issues AND it has been running FINE for the past 3 months....
ASUS Deluxe II X99
6950x etc
32 gigs 3400 ram
1080 x 2 SLI (x16)
SSD CARD in PCI-E slot etc...
Can someone please give me some advice/ help on how to get this idiotic issue fixed WITHOUT having to reformat/reinstall?