BSODs at random times atikmdag.sys THREAD STUCK IN DEVICE DRIVER

Page 3 of 6 FirstFirst 12345 ... LastLast

  1. Posts : 459
    Windows 8&10
       #21

    There are some older drivers on your system. That doesn't mean they are bad but you may want to check them out..

    gdrv.sys 7/2013
    lvrs64.sys 10/2012
    AVer330USB.sys 2/2014
    e22w7x64 3/2013
    lvuvc64.sys 10/2012
      My Computer


  2. Posts : 14,901
    Windows 10 Pro
       #22

    Network drivers and Logitech drivers mainly, wouldn't be too worried about them now but it is something to update after this problem is resolved :)
      My Computers


  3. Posts : 39
    Windows 10 Pro
    Thread Starter
       #23

    axe0 said:
    Take the time it requires to test
    Hi,

    Thanks for the quick reply :) I used it again for around 15 minutes and there was a BSOD again. What shall I do?

    EDIT: It happened again. Same BSOD
      My Computer


  4. Posts : 14,901
    Windows 10 Pro
       #24

    Either the RAM, mobo or PSU would be a likely cause. The CPU would be, in rare occasions.




    Diagnostic Test

     RAM TEST


    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 complete passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.


    Make a photo of the result and post it.

    Addition:
    If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
    If errors show up and you see them a lot later, no problem, the errors don't affect the test.
      My Computers


  5. Posts : 39
    Windows 10 Pro
    Thread Starter
       #25

    axe0 said:
    Either the RAM, mobo or PSU would be a likely cause. The CPU would be, in rare occasions.




    Diagnostic Test

     RAM TEST


    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 complete passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.


    Make a photo of the result and post it.

    Addition:
    If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
    If errors show up and you see them a lot later, no problem, the errors don't affect the test.
    I'll do it as soon as I get a chance, but it maybe later on in the week
      My Computer


  6. Posts : 39
    Windows 10 Pro
    Thread Starter
       #26

    Sorry for being quite late to do this (I have been very busy with college). I am currently running the MemTest and it's been almost 7 hours and I am on my 7th pass with no errors. I will post a picture when it gets to 8 passes.

    Thanks so much for helping, hopefully this will get resolved soon.
      My Computer


  7. Posts : 39
    Windows 10 Pro
    Thread Starter
       #27
      My Computer


  8. Posts : 39
    Windows 10 Pro
    Thread Starter
       #28

    I have attached a new dm log collector file, just in case.
      My Computer


  9. Posts : 14,901
    Windows 10 Pro
       #29

    Do you have a multimeter to test the PSU?
    PSU - Test DC Output Voltage - Windows 7 Help Forums
      My Computers


  10. Posts : 39
    Windows 10 Pro
    Thread Starter
       #30

    Unfortunately I do not have one
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 07:07.
Find Us




Windows 10 Forums