Last dump from 10/10 at 6:54PM shows these problems?
This belongs to Partition Management Driver or Partition Manager belongs to software Microsoft Windows Operating System. Unlikely to be the cause of a problem.
fffff800`9f29afc8 fffff809`91085690Unable to load image \SystemRoot\System32\drivers\partmgr.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for partmgr.sys
*** ERROR: Module load completed but symbols could not be loaded for partmgr.sys
Are you using Readyboost with a USB flash drive? If so, stop and see if that helps.
fffff800`9f29afe8 fffff809`91e31be0Unable to load image \SystemRoot\System32\drivers\rdyboost.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for rdyboost.sys
*** ERROR: Module load completed but symbols could not be loaded for rdyboost.sys
This belongs to Intel Matrix Storage Manager driver or Intel RAID Controller or Intel AHCI Controller by Intel. You can try the Intel drivers listed for Win 10 on the ASUSTek web site: ASUSTeK Computer Inc. -Support- Driver & Tools - G751JL
fffff800`9f29b6d8 fffff809`911e6918Unable to load image \SystemRoot\System32\drivers\iaStorA.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for iaStorA.sys
*** ERROR: Module load completed but symbols could not be loaded for iaStorA.sys
Also indicates memory_corruption. Painful though it may be I suggest you move both of the new memoru modulees to the internal, harder to get to slots and leave out th4e other 8GB module, then test and see how that goes. If okay then you can try installing the old 8GB module in the easy access slot and see how that goes. If problems remove it and stay with the 16GB.
Otherwise run memtest86+ (note the +). You will probably have to enable CSM for this to boot, just disable it when done.
Follow this tutorial: MemTest86+ - Test RAM - Windows 10 Forums
MemTest86+ is a diagnostic tool designed to test Random Access Memory (RAM) for faults. MemTest86+ will verify that:
- RAM will accept and keep random patterns of data sent to it
- There are no errors when different parts of memory try to interact
- There are no conflicts between memory addresses
Memtest86+ runs from bootable media to isolate the RAM from the system, no other components are taken into account during the test.
MemTest86+ needs to run for at least 8 passes to be anywhere near conclusive, anything less will not give a complete analysis of the RAM.
If you are asked to run MemTest86+ by a Ten Forums member make sure you run the full 8 passes for conclusive results. If you run less than 8 passes you will be asked to run it again.
MemTest86+ has been known to discover errors in RAM in later passes than the eighth pass. This is for information only; if you feel there is a definite problem with the RAM and 8 passes have shown no errors feel free to continue for longer.
Running 8 passes of MemTest86+ is a long and drawn out exercise and the more RAM you have the longer it will take. It's recommended to run MemTest86+ just before you go to bed and leave it overnight.