Windows 10: BSOD watching video Solved

Page 1 of 5 123 ... LastLast
  1.    04 Sep 2016 #1

    BSOD watching video

    Running Win 10 pro 64 bit 14393.105
    new build intel i7 6770k
    ASUS Z170 pro gaming
    【Kingston】HyperX Predator DDR4 DDR4-3333 8GBx2枚 1.35V

    This is the 2nd time I have had a BSOD in the last couple of days. It's pretty hot in Japan right now. Might be a heat issue, but I don't know.

    please advise,


    more crashes, added new file documenting those too
    Last edited by samhfoley; 04 Sep 2016 at 17:08.
      My ComputersSystem Spec

  2.    04 Sep 2016 #2

    don't know if I should keep updating the zip file as I get more BSOD or not.... keeps happening.
      My ComputersSystem Spec

  3. Ztruker's Avatar
    Posts : 6,437
    Windows 10 Pro X64 17134.191
       04 Sep 2016 #3

    Three of the dumps show
    BugCheck D1, {0, ff, e1, 0}
    Probably caused by : Unknown_Image ( nt!KiPageFault+247 )
    the other
    BugCheck A, {b0, ff, b7, fffff80053621627}
    Probably caused by : ntkrnlmp.exe ( nt!KiPageFault+247 )
    All 4 are
    An attempt was made to access a pageable (or completely invalid) address at an
    interrupt request level (IRQL) that is too high.  This is usually
    caused by drivers using improper addresses.
    Start by testing your PC memory:

    Follow this tutorial: MemTest86+ - Test RAM - Windows 10 Forums

    information   Information

    MemTest86+ is a diagnostic tool designed to test Random Access Memory (RAM) for faults. MemTest86+ will verify that:

    • RAM will accept and keep random patterns of data sent to it
    • There are no errors when different parts of memory try to interact
    • There are no conflicts between memory addresses

    Memtest86+ runs from bootable media to isolate the RAM from the system, no other components are taken into account during the test.

    warning   Warning
    MemTest86+ needs to run for at least 8 passes to be anywhere near conclusive, anything less will not give a complete analysis of the RAM.

    If you are asked to run MemTest86+ by a Ten Forums member make sure you run the full 8 passes for conclusive results. If you run less than 8 passes you will be asked to run it again.

    Note   Note
    MemTest86+ has been known to discover errors in RAM in later passes than the eighth pass. This is for information only; if you feel there is a definite problem with the RAM and 8 passes have shown no errors feel free to continue for longer.

    Running 8 passes of MemTest86+ is a long and drawn out exercise and the more RAM you have the longer it will take. It's recommended to run MemTest86+ just before you go to bed and leave it overnight.

    If nothing found then try Driver Verifier, see if it shows us anything:
    Driver Verifier
    is a diagnostic tool built into Windows 10, it is designed to verify both native Microsoft drivers and third party drivers. Driver Verifier's verification process involves putting heavy stress on drivers with the intention of making bad, outdated, incompatible or misbehaving drivers fail. The required result is a BSOD (Blue Screen of Death) which will generate a crash dump for debugging purposes.
    Machines exposed to Driver Verifier will run very sluggishly due to the stress being applied to the drivers.

    Driver Verifier - Enable and Disable in Windows 10

    Pay close attention to
    and make sure the correct boxes are checked.

    It is not advised to run Driver Verifier for more than 48 hours at a time. Disable Driver Verifier after 48 hours or after receiving a BSOD, whichever happens soonest.

    Always create a Restore Point prior to enabling Driver Verifier.

    What we're looking for is a BSOD with a mini dump that will tell us what driver caused it.
      My ComputersSystem Spec

  4.    05 Sep 2016 #4

    11 passes with memtest 86+ and no errors

    Loaded verifier according to the instructions and got a BSOD on my first boot attempt. 2nd time booted into OS. Don't know where to look for a report from verifier to upload. I ran the initial diagnostic again.
      My ComputersSystem Spec

  5. Ztruker's Avatar
    Posts : 6,437
    Windows 10 Pro X64 17134.191
       06 Sep 2016 #5

    The dump indicates a problem with AsIO.sys.
    BugCheck 1A, {1233, bdf8c, 0, 0}
    *** WARNING: Unable to verify timestamp for AsIO.sys
    *** ERROR: Module load completed but symbols could not be loaded for AsIO.sys
    Probably caused by : memory_corruption
    The one installed is very old: Wed Aug 22 05:54:47 2012
    The process known as AsIO belongs to software AsIO by ASUSTeK Computer (ASUS USA

    Description: AsIO.sys is not essential for the Windows OS and causes relatively few problems. AsIO.sys is located in the C:\Windows\System32\drivers folder. Known file sizes on Windows 10/8/7/XP are 5,685 bytes (35% of all occurrences), 4,962 bytes and 6 more variants.
    The driver can be started or stopped from Services in the Control Panel or by other programs. The AsIO.sys file is a file with no information about its developer. The program is not visible. There is no detailed description of this service. It is not a Windows system file. AsIO.sys appears to be a compressed file. Therefore the technical security rating is 45% dangerous, however you should also read the user reviews.
    Stop it in Services and see if that allows you to boot with Verifier active.
      My ComputersSystem Spec

  6.    06 Sep 2016 #6

    I think the BSODs might have been caused by awebCam driver problem that's happening with the new Microsoft anniversary update. I've unplugged my USB from my WebCam, uninstall the software, and haven't had a BSOD since
      My ComputersSystem Spec

  7. Ztruker's Avatar
    Posts : 6,437
    Windows 10 Pro X64 17134.191
       06 Sep 2016 #7

    That's good to know. Hope that's it.
    Is there a driver update for it?
      My ComputersSystem Spec

  8.    06 Sep 2016 #8

    Not that I know of. People with advanced preview versions of Windows 10 pro say that there's a fix, but those of us who don't have that yet don't have a fix
      My ComputersSystem Spec

  9. Ztruker's Avatar
    Posts : 6,437
    Windows 10 Pro X64 17134.191
       06 Sep 2016 #9

    Hopefully the fix will get rolled out in one of the updates to teh Anniversary edition.
      My ComputersSystem Spec

  10.    06 Sep 2016 #10

    Yeah me too. Funny, all the stress tests I was doing on my new overclock that failed before, are now working fine. So that's nice to know
      My ComputersSystem Spec

Page 1 of 5 123 ... LastLast

Related Threads
I have had 5 blue screens since I reinstalled windows from a update that did not install properly, also aswell as getting blue screens on the last install of windows 10, but I don't have the Mini dumps for that install. Usually the computer will...
I've been getting a BSoD since updating my nVidia drivers for Overwatch. The error I've been getting is "VIDEO_SCHEDULER_INTERNAL_ERROR". I get this BSoD when I am watching a video in full screen on one of my monitors(e.g YouTube, Twitch, Netflix,...
Random BSOD while watching Youtube video in BSOD Crashes and Debugging
Was watching a Youtube video when suddenly I got this BSOD called UNEXPECTED_STORE_EXCEPTION Thanks in advance!
BSOD while watching a youtube video in BSOD Crashes and Debugging
Hello. System specs: CPU: I5-4690k RAM: Kingston Fury 2x4GB MOBO: Z97-D3H GPU:R9 280x PowerColor PSU: NZXT Hale v2 Browser: Google Chrome OS: Windows 10 x64
I recently upgraded to Windows 10, and everything has been really smooth, except recently I've started getting increasingly frequent BSOD crashes. It usually gives me the IRQL_NOT_LESS_OR_EQUAL error, but sometimes I get other ones. It was fairly...
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 20:38.
Find Us