BSOD MEMORY_MANAGEMENT randomly throughout day

Diagnostics Test

 HDD TEST

   Note

Please run HDTune first, in the order posted!

Run HDTune to

• check the health,
• scan for errors, no quick scan but full scan
• run a benchmark.

It may take some time, but please take the time you need to perform it properly.
When above is done please make screenshots of the following

• the health,
• the error scan,
• the benchmark incl. following
  
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.

Run SeaTools DOS to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use - Windows 7 Help Forums
Run the long test.

   Note

Do not run SeaTools on an SSD as the results will be invalid.

Make a photo of the result and post it.

Run chkdsk
Disk Check - Windows 7 Help Forums
Use option TWO with parameter /r
Upload the chkdsk log Check Disk (chkdsk) - Read Event Viewer Log - Windows 7 Help Forums

"Chkdsk was executed in scan mode on a volume snapshot.

Follow the instructions carefully. Run the same command on each partition/drive.

Looks good, a correction to the file system on the SSD was made :)

Code:

CHKDSK discovered free space marked as allocated in the volume bitmap.Windows has made corrections to the file system.

Let us know how it goes.

Diagnostic Test

 DRIVER VERIFIER

   Warning

Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.

Please follow this tutorial to run driver verifier.

Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

   Note

Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.

If it would, your network drivers would be caught by driver verifier.


Please fill in your system specs

Please follow this tutorial and download the tool. The tool will give you detailed information about your system specs, please fill in your system specs more completely including PSU, cooling and other used stuff like mouse, keyboard, monitor, case, etc.
The PSU, cooling and other stuff are NOT mentioned in the tool.

In the left corner below in your post you find 'My System Specs'. After clicking it you can find a link a little below that says 'Update your System Spec', click on this link to get to the page where you can fill in your system specs.