Page 2 of 2 FirstFirst 12
  1.    31 May 2016 #11
    Join Date : May 2016
    Posts : 11
    Windows 10
    Thread Starter

    Well, I had a crash just before finishing the HDtool error test on the first 2TB drive. So I went ahead an loaded up an older version of the display driver. Seemed to be working fine, but it just crashed again with the same error. Not really sure what to do now.
      My ComputerSystem Spec
  2.    01 Jun 2016 #12
    Join Date : Jun 2015
    Posts : 12,693
    Windows 10 Pro
      My ComputersSystem Spec
  3.    01 Jun 2016 #13
    Join Date : May 2016
    Posts : 11
    Windows 10
    Thread Starter

    Latest error report. It's a different code this time.

    IRQL_NOT_LESS_OR_EQUAL
    0x0000000a
      My ComputerSystem Spec
  4.    01 Jun 2016 #14
    Join Date : May 2016
    Posts : 11
    Windows 10
    Thread Starter

    additionally here a the benchmark and health reports from the 2TB drives. I have not been able to complete an error scan as they take so long my system usually crashes before completion.
      My ComputerSystem Spec
  5.    01 Jun 2016 #15
    Join Date : Jun 2015
    Posts : 12,693
    Windows 10 Pro




    Sudden return of BSOD Diagnostic Test Sudden return of BSOD
     DRIVER VERIFIER

    warning   Warning
    Please make a backup of your important files and get your rescue media or create one.
    Please create a restore point.

    Please follow this tutorial to run driver verifier.

    Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

    Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

    If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

    Note   Note
    Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.
      My ComputersSystem Spec
  6.    02 Jun 2016 #16
    Join Date : May 2016
    Posts : 11
    Windows 10
    Thread Starter

    Sorry for the slow response. I ran Driver Verifier and it went a whole day and a half before it finally crashed again.

    Here is the latest error reports.
      My ComputerSystem Spec
  7.    03 Jun 2016 #17
    Join Date : Jun 2015
    Posts : 12,693
    Windows 10 Pro

    That is unfortunate, driver verifier caused the 0x1A crash but no driver has been flagged. This indicates we're dealing with another problem which usually is hardware.
    Lets try a standard test for the 0x1A




    Sudden return of BSOD Diagnostic Test Sudden return of BSOD
     RAM TEST

    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 complete passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.


    Make a photo of the result and post it.

    Addition:
    If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
    If errors show up and you see them a lot later, no problem, the errors don't affect the test.
      My ComputersSystem Spec
  8.    04 Jun 2016 #18
    Join Date : May 2016
    Posts : 11
    Windows 10
    Thread Starter

    memtest86 returned some errors, I'm trying to narrow it down to which stick is causing the error. Hopefully once that has been removed or replaced it will solve my issue.
      My ComputerSystem Spec
  9.    05 Jun 2016 #19
    Join Date : May 2016
    Posts : 11
    Windows 10
    Thread Starter

    I have found the faulty stick of RAM. I believe that was causing the issue. Thank you very much for all your help axe0.

    I'm going to go ahead and mark this as solved.
      My ComputerSystem Spec

 
Page 2 of 2 FirstFirst 12


Similar Threads
Thread Forum
All of a sudden 2 new Driver Power State Failure BSOD have happened!!
3 month old laptop, i76700 HQ Quad Core Processor, NVidia GTX 950m, 512 SSD, 4K Touchscreen, 16 GB RAM Axe0 I am trying to upload the 2 dump files but I am having a lot of trouble. First I can't even find the one that just happened 30 minutes ago...
BSOD Crashes and Debugging
Return from W10 to W7
Is there anyway I can replace W10 with W7.This small notebook I purchased came with W8 installed and I then took the free upgrade to W10 but however hard I try W10 is not for me.
Installation and Upgrade
Sudden and unexpected BSOD on Win10
Hello all, I have a self-built CP with above average specs running Win10. Every once in a while I'll get a BSOD when I'm not necessarily doing anything in particular. I thought I'd try using a few of the debugging tools to figure out ...
BSOD Crashes and Debugging
Solved How do I return to Windows 7
Hello Windows 10 experts, Windows 10 has been a frustrating problem and huge annoyance for me! I won't go into all of the crashes and problems. There is nothing in this operating system that I find of value! :mad: I would rather return to...
Installation and Upgrade
Return to W8.1
I tried 10074 and 10122 so the question is can I return to 8.1 Thanks
General Support
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 06:54.
Find Us
Twitter Facebook Google+ Ten Forums iOS App Ten Forums Android App



Windows 10 Forums