Windows 10: Tablet has bluescreens during night/standby

Page 2 of 3 FirstFirst 123 LastLast

  1. Posts : 13,351
    Windows 10 Pro
       23 May 2016 #11

    It doesn't 100% verify what I think happens, I thought that the BSOD happened at the beginning or the end, but as there is no driver flagged in the dump we'll need to run driver verifier. Most other usual causes are ruled out so that is a good sign :)
    Please follow below instructions.




    Tablet has bluescreens during night/standby Diagnostic Test Tablet has bluescreens during night/standby
     DRIVER VERIFIER

    warning   Warning
    Please make a backup of your important files and get your rescue media or create one.
    Please create a restore point.

    Please follow this tutorial to run driver verifier.

    Some windows drivers are blamed in a few crashes, but that usually means that a 3rd party driver is actually the cause.
    Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

    Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

    If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

    Note   Note
    Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.


    Usual causes:
    • Memory corruption,
    • Hardware (memory in particular),
    • Overclocking failure,
    • Installing a faulty or mismatched hardware (especially memory) or a failure after installing it,
    • 3rd party firewall,
    • Device drivers,
    • SCSI/network/BIOS updates needed,
    • Improperly seated cards,
    • Incompatible storage devices,
    • Overclocking,
    • Virus scanner,
    • Backup tool,
    • Bad motherboard,
    • Missing Service Pack
      My ComputersSystem Spec


  2. Posts : 64
    Windows 10
    Thread Starter
       23 May 2016 #12

    I have activated it, rebooted and now Windows doenst start anymore there is bluescreen at Windows start...
      My ComputerSystem Spec


  3. Posts : 13,351
    Windows 10 Pro
       23 May 2016 #13

    Partly that is a good sign, have you tried my suggestions for getting back in Windows like driver verifier reset, safe mode or a restore point?
      My ComputersSystem Spec


  4. Posts : 64
    Windows 10
    Thread Starter
       23 May 2016 #14

    I cant get into windows because it automatically runs into bluescreen, it did that for 2 or 3 times, then "automatic repair" was started, I selected "repair last" or something, there was nothing else to select anyway (I created a manual repair point before turning on the tool), now it's frozen and doesn't do anything anymore since 5 minutes...
      My ComputerSystem Spec


  5. Posts : 13,351
    Windows 10 Pro
       23 May 2016 #15

    After 3 times boot failure you should get the troubleshooting options, go into the advanced troubleshooting options and in there choose command prompt, then enter the command
    Code:
    verifier /reset
      My ComputersSystem Spec


  6. Posts : 64
    Windows 10
    Thread Starter
       23 May 2016 #16

    Ok Im back in Windows, repair took a bit longer than expected, working again, seems it used the last repair point. Now what? And no, the automatic repair didn't give me any advanced options, just reboot and "repair last".
      My ComputerSystem Spec


  7. Posts : 13,351
    Windows 10 Pro
       23 May 2016 #17

    Please run the DM Log Collector again, with the BSODs dumps should have been created which we need to analyze to find out what driver caused it.
      My ComputersSystem Spec


  • Posts : 13,351
    Windows 10 Pro
       23 May 2016 #18

    muffle said: View Post
    Ok Im back in Windows, repair took a bit longer than expected, working again, seems it used the last repair point. Now what? And no, the automatic repair didn't give me any advanced options, just reboot and "repair last".
    No problem, I'm just glad you're back in Windows already :)
      My ComputersSystem Spec


  • Posts : 64
    Windows 10
    Thread Starter
       23 May 2016 #19

    done.
      My ComputerSystem Spec


  • Posts : 13,351
    Windows 10 Pro
       23 May 2016 #20

    Please update/reinstall Unified Remote 3.
    Code:
    1: kd> lmvm uvhid
    Browse full module list
    start    end        module name
    8e2b0000 8e2b9000   uvhid    T (no symbols)           
        Loaded symbol image file: uvhid.sys
        Image path: \SystemRoot\System32\drivers\uvhid.sys
        Image name: uvhid.sys
        Browse all global symbols  functions  data
        Timestamp:        Tue Mar 22 10:42:48 2016 (56F11398)
        CheckSum:         0001557A
        ImageSize:        00009000
        Translations:     0000.04b0 0000.04e4 0409.04b0 0409.04e4
      My ComputersSystem Spec


  •  
    Page 2 of 3 FirstFirst 123 LastLast

    Related Threads
    ntoskrnl.exe and win32kbase.sys bluescreens in BSOD Crashes and Debugging
    I've gotten tons of bluescreens ( from ntoskrnl.exe and win32kbase.sys) They range from SYSTEM_SERVICE_EXCEPTION to ATTEMPTED_WRITE_TO_READONLY_MEMORY AND DRIVER_OVERRAN_STACK_BUFFER I have verified that the memory is, indeed, flawless with...
    After a night's sleep in Performance & Maintenance
    A friend's desktop computer has not been staying in sleep mode over night. At least he would discover the fans running if he got up during the night. A restart would be required in the morning. I requested that he revise his power options to have...
    BSOD Dumps Here are minidumps of the past several bluescreens, and a full memory dump of the most recent one. I've been getting these for various reasons - I already fixed a few problems with programs chewing up hard disk and causing crashes due...
    first night with 10 in General Support
    Funny, ha ... if mod or admin wants to move to chillout - ok. whatever... After finding tablet mode, and using 10240, this is the first night in more than 3 years that I would use an OS other than 8 / or server. Tablet Mode works even...
    Kernel Bluescreens in BSOD Crashes and Debugging
    It's me again. I fixed all my previous bluescreen errors and havent been getting them for some time, but out of nowhere I started getting them again. 13460
    Our Sites
    Site Links
    About Us
    Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

    Designer Media Ltd
    All times are GMT -5. The time now is 22:33.
    Find Us