Hi Moonky,
Welcome to the 10forums :)
The crashes are 0xD1, an indication of a driver, it seems you've used driver verifier already although I'm wondering where you get those settings.
Code:
STANDARD FLAGS:
[X] (0x00000000) Automatic Checks
[X] (0x00000001) Special pool
[X] (0x00000002) Force IRQL checking
[X] (0x00000008) Pool tracking
[ ] (0x00000010) I/O verification
[X] (0x00000020) Deadlock detection
[ ] (0x00000080) DMA checking
[X] (0x00000100) Security checks
[X] (0x00000800) Miscellaneous checks
[X] (0x00020000) DDI compliance checking
ADDITIONAL FLAGS:
[ ] (0x00000004) Randomized low resources simulation
[ ] (0x00000200) Force pending I/O requests
[ ] (0x00000400) IRP logging
[ ] (0x00002000) Invariant MDL checking for stack
[ ] (0x00004000) Invariant MDL checking for driver
[ ] (0x00008000) Power framework delay fuzzing
[ ] (0x00010000) Port/miniport interface checking
[ ] (0x00040000) Systematic low resources simulation
[ ] (0x00080000) DDI compliance checking (additional)
[ ] (0x00200000) NDIS/WIFI verification
[ ] (0x00800000) Kernel synchronization delay fuzzing
[ ] (0x01000000) VM switch verification
[ ] (0x02000000) Code integrity checks
[X] Indicates flag is enabled
However since driver verifier was unable to flag any driver + pagefaults (drivers passing bad data to memory or passing data to corrupted memory) there are 2 options.
1. Driver verifier didn't flag any driver because it didn't check the setting that was violating
2. The pagefault was caused due to bad memory.
I suggest that you start with running MemTest86+ for 8 straight completed passes or until errors show up as the tutorial describes.
Run
MemTest86+ to analyse your RAM.
MemTest86+ - Test RAM - Windows 10 Forums
Note
MemTest86+ needs to be run for
at least 8 complete passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for
zero errors here. Even a single error will indicate RAM failure.
Make a photo of the result and post it please.
Addition:
If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
If errors show up and you see them a lot later, no problem, the errors don't affect the test.
Code:
6: kd> k
# Child-SP RetAddr Call Site
00 ffffd001`869472f8 fffff803`5fbd62e9 nt!KeBugCheckEx
01 ffffd001`86947300 fffff803`5fbd4ac7 nt!KiBugCheckDispatch+0x69
02 ffffd001`86947440 00000000`00000000 nt!KiPageFault+0x247