BSOD kernel security check failure

Hi Strat,

Welcome to the 10forums.

It looks like most of the crashes are caused by a Xbox driver, if no Xbox device is connected when the crashes occur please proceed to the troubleshooting instructions below.
If any Xbox device is connected, please reinstall/update the drivers and/or disconnect it.

Code:

dc1-controller	Xbox Peripherals Driver	c:\windows\system32\drivers\dc1-controller.sys

11: kd> lmvm dc1_controller
start             end                 module name
fffff800`43e00000 fffff800`43e17000   dc1_controller   (pdb symbols)          d:\symbols\dc1-controller.pdb\AE6D1540A3DC469998C9AF2C7036287E1\dc1-controller.pdb
    Loaded symbol image file: dc1-controller.sys
    Mapped memory image file: d:\symbols\dc1-controller.sys\5632DA1E17000\dc1-controller.sys
    Image path: \SystemRoot\System32\drivers\dc1-controller.sys
    Image name: dc1-controller.sys
    Timestamp:        Fri Oct 30 03:46:54 2015 (5632DA1E)
    CheckSum:         00010481
    ImageSize:        00017000
    File version:     1.0.0.1
    Product version:  1.0.0.1
    File flags:       0 (Mask 3F)
    File OS:          40004 NT Win32
    File type:        3.7 Driver
    File date:        00000000.00000000
    Translations:     0409.04b0
    CompanyName:      Microsoft Corp.
    ProductName:      DC1 Controller KMDF driver
    InternalName:     DC1Controller.sys
    OriginalFilename: DC1Controller.sys
    ProductVersion:   1.0.0.1
    FileVersion:      1.0.0.1 (th2_release.151029-1700)
    FileDescription:  KMDF driver for DC1 Controller
    LegalCopyright:   Copyright (C) 2012 Microsoft Corp.

Even though you already tested the memory, please test it again according to the instructions below.

Hardware Troubleshooting

Read carefully before proceeding.

   Warning

If you're overclocking your system, revert back to stock clocks now.

   Note

Test the system once the overclock is removed before continuing with the steps outlined below.

Part One: CPU Stress Test
Part Two: MemTest86+ RAM Diagnostic
Part Three: Hard Drive Diagnostics
Part Four: GPU Stress Test

ONE

 CPU TEST

Run Prime95 and/or IntelBurnTest to stress test your CPU. Prime95 - Stress Test Your CPU - Windows 10 Forums & CPU - Stress Test Using IntelBurnTest - Windows 7 Help Forums

   Warning

Your CPU temperatures will rise quickly while under this stress test. Keep a keen eye on them and abort the test if overheating occurs.

TWO

 RAM TEST

Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

   Note

MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking forzero errors here. Even a single error will indicate RAM failure.

THREE

 HDD TEST

Run SeaTools to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use - Windows 7 Help Forums
Run following tests

1. Short Drive Self Test
2. Short generic
3. Long generic

If the short generic fails, no need for the long generic.

   Note

Do not run SeaTools on an SSD as the results will be invalid.

Run chkdsk
Disk Check - Windows 7 Help Forums

Run HDTune to

• scan for errors, no quick scan but full scan
• check the health,
• benchmark.

It may take some time, but please take the time you need to perform it properly.
Let me know what the results are

• of the error scan,
• make a screenshot of the health of every hard drive and post the screenshots,
• post screenshots with the benchmark of the
  
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.

FOUR

 GPU TEST

Run Furmark to stress test your GPU. FurMark - GPU Stress Test - Windows 10 Forums

   Note

Run Furmark for around 30 minutes.

   Warning

Your GPU temperatures will rise quickly while Furmark is running. Keep a keen eye on them and abort the test if overheating occurs.

Why is driver verifier enabled? You can't simply enable driver verifier unless instructed by an analyst as it may cause your system to become unbootable.
Please disable driver verifier

• Open an admin command prompt
• Enter "verifier/reset" (without quotes)

Daemon tools, Alcohol 120% and Power Archiver Pro uses SCSI Pass Through Direct (SPTD), which is a well known cause for BSOD's.
Please remove Daemon Tools and run the SPTD pass through remover.

1. Uninstall Daemon Tools
2. Download the SPTD standalone installer and follow these steps:
   
   • Double click the executable to open it
   • Click on the button shown below

If the button is grayed out, like in the image, there is no more SPTD installation on your system, and you can close the window

The last crash was unable to create a dump of it and without dump I can't interpret something about it because the kernel security crash isn't a crash that is specific related to something.
This means that we now do need driver verifier.

Diagnostic Test

 DRIVER VERIFIER

   Warning

Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.

Please follow this tutorial to run driver verifier.

Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

   Note

Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.

Code:

Event[41771]:
  Log Name: System
  Source: Microsoft-Windows-WER-SystemErrorReporting
  Date: 2016-02-25T00:19:30.151
  Event ID: 1005
  Task: N/A
  Level: Error
  Opcode: N/A
  Keyword: Classic
  User: N/A
  User Name: N/A
  Computer: DESKTOP-JUME3CU
  Description: 
Unable to produce a minidump file from the full dump file.