Windows 10: Somewhat uncommon BSOD

Page 3 of 5 FirstFirst 12345 LastLast
  1. axe0's Avatar
    Posts : 13,707
    Windows 10 Pro
       14 Jan 2016 #21

    frish said: View Post
    That comment was more towards if I noticed it and had to do it for ~5 weeks. Though I suppose there's always turning the settings down too. Nevertheless I was and will be trying it. In some ways it'd be more convenient if I could be sure they'd happen a little more consistently.
    You can try running driver verifier to see if it helps forcing the bluescreens.

    Somewhat uncommon BSOD Diagnostic Test Somewhat uncommon BSOD

    warning   Warning
    Please make a backup of your important files and get your rescue media or create one.
    Please create a restore point.

    Please follow this tutorial to run driver verifier.

    Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

    Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

    If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

    Note   Note
    Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.
      My ComputersSystem Spec

  2.    14 Jan 2016 #22

    I did try late last year to use driver verifier. It managed to bsod straight away and I had to system restore. Should I try again? I also removed the sb audigy driver that was on since the last bsod since I didn't originally do that.
      My ComputerSystem Spec

  3. axe0's Avatar
    Posts : 13,707
    Windows 10 Pro
       14 Jan 2016 #23

    Yes please, this time try to disable verifier (in a few ways possible) before using a system restore please.
      My ComputersSystem Spec

  4.    14 Jan 2016 #24

    Bsod happens straight away mentioning irql_not_less_or_equal. Then after using the command prompt to disable it I got a bsod, then it reset with another bsod mentioning "system service exception". One more restart and it restarts just fine. Though it does have an error for "Tablet version mismatch- Please reinstall the tablet software", presumably my bamboo fun tablet that I probably had it's drivers before updating to windows 10. It doesn't often get used and have had times without installing the drivers previously when not using it for a while. Wasn't sure if you just wanted the minidump, but the full thing is attached below. As well as the pop up message in case it has any relevance to something happening. Last time I tried using driver verifier I did try not using system restore, Though maybe I didn't give it another chance after the 2nd bsod after the command prompt usage, I can't quite remember. I just recall overall letting it reset a fair amount of times.
      My ComputerSystem Spec

  5. axe0's Avatar
    Posts : 13,707
    Windows 10 Pro
       14 Jan 2016 #25

    3 of the 4 dumps are corrupted, meaning the size of the file is incorrect (0KB)
    Attachment 58793

    It seems the audio drivers are getting part of it.
    You did already check GIGABYTE - Moederbord - Socket 1155 - GA-Z77X-UD5H (rev. 1.0)
    and reinstall/update the drivers, right?
    ffffd000`20c080f8  fffff800`376d9438Unable to load image \SystemRoot\system32\drivers\MBfilt64.sys, Win32 error 0n2
    *** WARNING: Unable to verify timestamp for MBfilt64.sys
    *** ERROR: Module load completed but symbols could not be loaded for MBfilt64.sys
    3: kd> lmvm MBfilt64
    start             end                 module name
    fffff800`376d0000 fffff800`376de000   MBfilt64 T (no symbols)           
        Loaded symbol image file: MBfilt64.sys
        Image path: \SystemRoot\system32\drivers\MBfilt64.sys
        Image name: MBfilt64.sys
        Timestamp:        Fri Jul 31 05:40:32 2009 (4A7267B0)
        CheckSum:         0000FF02
        ImageSize:        0000E000
        Translations:     0000.04b0 0000.04e4 0409.04b0 0409.04e4
      My ComputersSystem Spec

  6.    14 Jan 2016 #26

    The realtek ones I figured I'd get direct from the link when you listed the drivers to update. In previous installations for windows 7 I did install form the motherboard site. I decided to try the motherboard one, it updated the speaker and mic drivers after restart, then gave a bsod. I tried relaunching it and it bsod straight away in windows and I couldn't go back in until I disabled driver verifier in the command prompt which I assumed would be fully disabled now. I have loaded the verifier to disable the settings and restarted just in case. The Atheros driver as well as other were gotten from the mobo site, atheros for example was using the windows 8 driver since there wasn't a win 10 version available.

    Other drivers only listed for windows 7 or 8 (or 8.1) I didn't install for this installation were:
    Creative SB X-Fi driver
    Realtek Function driver for Realtek Azalia audio chip (Including Microsoft UAA Driver in English edition)
    Intel SATA Preinstall driver
    (For AHCI / RAID Mode)
    Hot fix (windows 8 only, not 8.1)
    (Note) After installed IRST driver, please install Hot fix.
    Marvell Storage Utility
    Intel VGA Driver (I believe I disabled it in the bios for some reason)

    I'm assume you're right with there being an issue with the audio drivers.

    Edit: Though I should say that some may have been installed pre the windows 10 update and before trying the driver booster thing as well as previous installations.
      My ComputerSystem Spec

  7. axe0's Avatar
    Posts : 13,707
    Windows 10 Pro
       14 Jan 2016 #27

    Do you have a restore point prior using driver booster?
    It is important to get rid of the installed drivers.

    This time the Intel audio driver tried to access invalid memory for which it didn't have permission to.
    *                                                                             *
    *                        Bugcheck Analysis                                    *
    *                                                                             *
    An attempt was made to access a pageable (or completely invalid) address at an
    interrupt request level (IRQL) that is too high.  This is usually
    caused by drivers using improper addresses.
    If a kernel debugger is available get the stack backtrace.
    Arg1: 0000000000000000, memory referenced
    Arg2: 0000000000000002, IRQL
    Arg3: 0000000000000000, bitfield :
    	bit 0 : value 0 = read operation, 1 = write operation
    	bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
    Arg4: fffff8015285c038, address which referenced memory
      My ComputersSystem Spec

  8.    14 Jan 2016 #28

    Unfortunately I don't, I did have one but I guess it's been too long and since been removed. I suppose I should reset my pc and then continue to diagnose the issues after updating the drivers? If that's what needs to be done, is the option to keep my files fine?
      My ComputerSystem Spec

  9. axe0's Avatar
    Posts : 13,707
    Windows 10 Pro
       14 Jan 2016 #29

    You could go through the devices in device manager and try reverting back the drivers, although with the process we've been through I'm not 100% certain it'll remove all the drivers installed by driver booster but some removed onces revert to driver booster installed onces.
      My ComputersSystem Spec

  10.    14 Jan 2016 #30

    I decided to just do the reset in the end. The increased BSODs recently could just be driver booster messing up the drivers and I figured it'd just be simpler to reset things than being uncertain whether there'd still be things hanging around that shouldn't be there. I'll be in the process of reinstalling things and drivers. Though I will say that I'm not completely sure whether to ignore or try to install some of the windows 7/8 drivers that aren't listed in the windows 10 section such as the Qualcomm drivers you first mentioned, though will hold off until your reply first. Perhaps they're relying on the intel network connections driver instead now that is there. The realtek drivers installed fine, will finish the rest off.

    Thanks again for your time so far, I hope I haven't been too much of a pain. Is it still a good idea to keep my gpu in the 2nd slot? Not that I'm in a rush to swap it back. I partially hope the BSODs will calm it down (and partially not if it makes it a pain to diagnose with rare issues). Though I haven't tried the windows 10 specific drivers.
      My ComputerSystem Spec

Page 3 of 5 FirstFirst 12345 LastLast

Related Threads
Hi, i got this computer about 3~ Weeks ago, and have gotten random BSOD's after that. System Information Bellow Intel Core i5-6600K 3.5Ghz @ 3.5 GeForce GTX960 2gb GDDR5, Physx CUDA 1TB Harddisk 7200RPM 8Gb DDR4 2133Mhz Dual Channel, 2x4gb...
BSOD during bootup (black screen 2min -> BSOD) in BSOD Crashes and Debugging
Hello I recently upgraded to Windows 10 from 7. I did choose the non-clean install, and i wish to keep it this way. i do NOT wish to clean install, as id rather just fix the problem. Anyways, my problem is; During the boot process, the pc...
I recently upgraded my htpc from 8.1 pro to Win 10 pro. I have had multiple BSOD since then. 4 were for store exception not handled and the last 2 were for kmode exception not handled mv91xx.sys. Please advise.
Hi, Over the past couple of days I have been having reasonably frequent BSODs. Some have not created a dump file. I cant pinpoint anything in particular but it seems to be pointing to a driver issue but never identifies the driver from what I can...
Our Sites
Site Links
About Us
Windows 10 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 10" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 05:15.
Find Us