Multiple BSODS within 2 days need solution ASAP

axe0 said:

Reload the dump, you have symbol problems.
Symbol problems are usually gone after a few times dump reloading.
Symbol problems may cause the dump to show different things then actually present in the dump.

Symbol problem:
Attachment 57609

When the symbol errors are gone and you still see atikmdag.sys as probable cause, follow instructions below
Please uninstall everything of AMD using Display Driver Uninstaller and install new drivers from AMD. Be sure to ONLY install the display drivers using custom/advanced options.
Attachment 57610

I've reopened the dump and still get the Symbol error. Am I not understanding something?

axe0 said:

It sometimes takes quite some open, close and reopen attempts to get it removed.
I assume you have setup the symbol path and workspace properly?

I think so, I'll send the two most recent dumps. Thanks a ton in advance!

axe0 said:

Please be sure about it: WinDBG - Install Configure - Windows 10 Forums

The dump you posted is a verifier dump (0xC4)
You can see verifier is enabled

Code:

DEFAULT_BUCKET_ID:  VERIFIER_ENABLED_VISTA_MINIDUMP

The 0xC4 crash can however occur with and without verifier enabled.

If you have followed my instructions above, then it is a good idea to stress test the GPU

Diagnostic test

 GPU TEST

Run Furmark to test your GPU. Furmark tutorial

   Note

Run Furmark for around 30 minutes

   Warning

Your GPU temperatures will rise quickly while Furmark is running. Keep a keen eye on them and abort the test if temperatures rise too high

Please fill in your system specs

Please follow this tutorial and download the tool. The tool will give you detailed information about your system specs, please fill in your system specs more completely.

How to fill in your system specs:

Alright, I'll start up FurMark, does it leave some sort of diagnostic file after it's done running? Also I disabled verifier as of now. I'll put my specs on my page then take care of DDU

axe0 said:

You only need to focus on artifacts and the temps.
You need to keep a keen eye on for monitoring what makes a log not necessary :)

So I ran Furmark. my fans were going 73 percent. Made a screenshot, where are the screenshots located under Furmark? I'm also taking care of DDU right now I'll keep you posted